Builds FZJ60 build (2 Viewers)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Last edited:
Tan
 
I love white Cruisers so I will say white #1, but otherwise - Tan
 
image.jpg
Freshening up the 1FZ before it goes back into the frame. Replacing every gasket, seal, hose, grommet and belt with all OEM parts. also replacing the water pump and AC compressor (Aisin, Denso)
 
image.jpg
Almost done, waiting on new knock sensors then I’ll put the intake back on. Should be painting the frame next week.
 
You bringing it to SAS3?
 
3F758936-3A82-4FD4-BA4B-F67FF6F986F3.jpeg
6A7C7E9E-6401-48A3-9E97-D202CC50B9B1.jpeg

Motor done, just need to swap the top of the AC compressor and install the belts.
 
Pretty! Sub'd.
 
Update time:
Painted frame and axles John Deere Blitz Black then assembled chassis.
New OEM Parts
All soft brake lines ( including first gen Tundra extended lines)
Brake line mounting tabs
Non ABS front hard lines
5 new FJ Cruiser steelies
All lug nuts
Rear locker guard
Most hardware

New aftermarket:
555 tie rod ends
Bilstien shocks
OME stabilizer

Ordered new starter and OEM power steering lines today. Sending off the drive shafts and mounting the fuel tank this week.
B2766FB0-8123-482C-B4EA-B39FA447C8EB.jpeg
10040FF5-A2A9-4AED-80CD-1AB65DA4063C.jpeg
35556AB2-F72D-43A7-BAF1-86FCCF77DDAB.jpeg
72EA0C56-D434-4167-BA3D-D4BD6064EB99.jpeg
 
Last edited:

Users who are viewing this thread

Back
Top Bottom