I finally got the lift moved over to the new shop, just in time to replace a rear axle seal. Its started to leak a little more, so I am going to try to get it knocked out this week! I also have a new winch cable and fairlead that have been laying...
Did you check that the Cat 5 cable is plugged in to the Display Panel and the Control Box, easy to swap it out with a new one if you suspect its damaged. Then as stated above check your 12VDC + and - to make sure they have power and ground...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.