Builds 73 FJ40 Refresh (4 Viewers)

[knuckle47]

I had ordered these last night, this morning I got the email that they’re arriving tomorrow… the Amazon of commercial parts?

 

[Living in the Past]

I used this and the baby powder - I also put the tubes mostly in the check freezer to contract some and the foam in the sun before I slid the foam over

Not sure how much you gain with copper putting in the freezer. Used in HVACR coils because of it heat transfer properties. Even with Arizona's low desert humidity items pulled out of the freezer with have humidity condense and freeze quickly. Copper may warm up too quickly to have humidity freeze. But the little bit gained is not worth it if any moisture collects on the outside of the copper.

 

[73FJ40]

Not sure how much you gain with copper putting in the freezer. Used in HVACR coils because of it heat transfer properties. Even with Arizona's low desert humidity items pulled out of the freezer with have humidity condense and freeze quickly. Copper may warm up too quickly to have humidity freeze. But the little bit gained is not worth it if any moisture collects on the outside of the copper.

A 100 deg F change in temperature will change the diameter of a 3/4 inch O.D. copper alloy tube by about 0.0015". Work fast.

I don't know how much frost will increase the diameter.

 

[charliemeyer007]

I think cold reduces the diameter by the amount per degree below standard conditions 68F?
There things like water becoming that increase when its freezes.

 

[73FJ40]

I think cold reduces the diameter by the amount per degree below standard conditions 68F?
There things like water becoming that increase when its freezes.

Refer to post #463.

 

[Engineer8000]

Gathering wing window hardware, somehow missing a washer. Ready to assemble front seat belt buckles.

Missing 90201-09221, NLA, thought I had them plated but guess not. I ordered some thick M8 plate washers, nobody will know.

 

[Engineer8000]

A lot easier to assemble than take apart.

 

[Engineer8000]

Accelerator pedal, another 73 only item.

 

[Engineer8000]

I ended up with a couple extra springs, Any ideas? Edit, the larger one is for the cowl vent mechanism, one to go.

 

[FJ40Savvy]

Amazing work. I would suggest a new title for the thread. "Refresh" under estimates that the attention to detail and effort you are doing to complete this build.

Can I send Louie to you for a refresh.

 

[knuckle47]

You know I was chomping at the bit to say the same thing….your detailing is truly impeccable and your focus is way beyond many. I can’t wait to see the truck when your finished

 

[Rochfort]

View attachment 3399183

Pin out:

View attachment 3399187

Proposed draft schematic for my truck:

View attachment 3399247

...somebody is trying to tell me those turn signals on the wheel wells belong on my '78 FJ43, and not the side ones I have currently. Anyone know?

 

[firemanj92]

I ended up with a couple extra springs, Any ideas? Edit, the larger one is for the cowl vent mechanism, one to go.
View attachment 3985567

coil spring-Fuel filter?

 

[Engineer8000]

The body guy is just so slow, gives me plenty of time to detail this stuff.