FJ40 | BJ40

Classifieds: Toyota 40-series Land Cruiser

Filter by prefix:

1978 FJ40 in Kansas
I am posting this for sale for my dad. There are some details I forget but he should be able to answer questions on it. For sale is a 1978 Landcruiser FJ 40 with the 2F inline 6 and 4-speed manual tranny sitting on 37” Toyo Mud Country tires and 15” aluminum wheels. The cruiser has been stretched to I’m thinking 105 but I would need to confirm. The Front axle is a FJ60 (wider) with mini-truck hi-steer. We swapped the axle out instead of converting the stock FJ40 axle to mini truck knuckles because the brakes were better on the FJ60, wider track width (I think 3” or so) and the right stud pattern for the high-steer on the knuckles. My dad replaced seales and repack’d bearings when he put this under the cruiser. The front suspension...
1980 FJ40 - Wisconsin
Clear WI title w/ current tags. Factory power steering, Weber carb (w/ 1 piece adapter), brand new BFGs. Has had body work done in the past, some was good work, but needs some more. I'd call it a 20 footer...looks good from 20 feet away...no top (although I have all the windows for the hardtop including the vent ones). I do have the doors, but they're in rough shape at the bottoms. PO cut one of the tops off, he was going to make them into 1/2 doors. Interior is ok, bucket seats w/ shoulder belts, OEM rubber floor mats, roll bar, no jump seats. gas tank in the rear between the frame rails. The bad: some frame rust in the back has made the vehicle un-roadworthy IMO. both rear spring perches are soft and last time I drove it I could...
I need a few parts for my project - doors, roof, hatch. shuold i buy a whole, Pa-rusty, A-title 69 fj40? the frame has bad repairs in the wheel arches. but it is complete - seats, gauges, running boards, hubcaps etc. but remember all has been sitting in the Pa salt. tub is probably gone. will i get any money for parts? Would someone actually want it whole to restore? your opinons are valued. thanks
'77 FJ40 For Sale-ish feeler (Maine)
'77 FJ40 For Sale in Maine (Hard top installed and More Photos!) I've been doing a lot of thinking lately, and I'm afraid I may have to sell the 40. She's a '77, and a good overall driver, but no means perfect. It runs well, 4 hi and low work perfectly, and shifts smoothly. ODO says 125k, but it said that when I bought it too ;) I'd guess around 130-40k, but I honestly don't know for sure. There is some rust poping up here and there on the body, but nothing too serious. (although, to be honest, the rear spring mounts are going to need attention soon. The rest of the frame is solid.) It could still easliy be repaired without too much work. I have the hardtop and doors as well, in good condition. Some of the good points are...
Hi, Im looking for a fj40 in decent condition. I've had two fj60s, and I want to try a 40 for once. Can be frankenstein in body panels, but has to have as least rust as possible. 350 is preferred over a toyota engine, but i'm really open to any ideas as 2-3k is my budget. Im located in the South, about 2 hours fron Atlanta. Either reply to this thread or send me a message. Thanks!!!
THIS THREAD IS POSTPONED UNTIL I FIX THE FJ40. I BLEW A ROD WHILE DOING 80 ON THE HIGHWAY YESTERDAY. BETTER NOW THAN AFTER A TRADE... bbalbano/71FJ40 - Photobucket - Video and Image Hosting My build thread is in my signature line. There are a few loose ends that I will be finishing this week, wipers, marker lights a a few odds and ends, it will be complete before the trade. Here are some links to some photos of my build. Ive spent over a year restoring my 71 fj40. Dont really want to do this, but my wife's transmission is starting to go, and once it does we will be without a car. Please dont try to trade me your beater. I need a reliable car for the family so let me know what you have. Thanks Brian
67 fj40, need to sell unfortunatly
here are the specifics, if your interested email me at sofindetermined@yahoo.com since im not on this site very often. id like 2500 bucks but im open to offers. im located in bonney lake/sumner. in washington. 1967 toyota fj40 cruiser. body is mostly rust free. very solid for a 67 that has had very little body work done. has a healthy 350 chevy engine with headers and 3 inch full exhaust. brand new edelbrock carb. custom adapter to run a recently rebuilt 76 4 speed landcruiser tranny (hydrolic converted) with a custom adapter to run a 67 "3 speed" transfer case. (lower geared then the 4 speed one)also have a high clearance t case crossmember. brand new throwout bearing brand new pilot bearing centforce clutch still lots of life on...
No interest or affiliation-:hillbilly: Just giving anyone in central New Jersey a heads up that there's a round bezel FJ40 sitting out front of a recycler down the street from my house. Someone brought it in for scrapping I would presume and they set it out front probably hoping to sell it whole. Not sure of the year as I just stopped in there around dark. Has a four speed plate on the dash so I would say between 75-78? Has stock six under hood. Some obvious rot and last registered up in Vermont I think. Give them a call if interested- Prices Auto Recyclers Inc 831 Route 539 New Egypt, NJ 08533 (609) 758-0015
FS 70 FJ40 in Wisconsin
I have a 70 FJ40 originally purchased in California. It has not been driven on the winter roads of Wisconsin. There is a little bit of rust under the rear gate, a little bit under passenger door and a little bit in the bed where the original roll bar was at due to prior owner putting carpet under bar. I have owned for the last 10 years with high hopes of making it an awesome looking 40 but with Kids in sports and to many other toys some must go to make room for others. I hate to see it go but I need the room and money for other projects. I posted before but the post can no longer be accessed so I thought I would just repost. List of items are as follows: - Electronic Crane Cam Fireball ignition. - New Radiator - New battery...
i have a 71-40 project car, body only, no top or front doors. It's straight enough with uncut rear fenders but has one patched up rear corner that probably should be fixed with new metal but right now it looks ok. The fenders are pretty straight and the hood for it is perfect. It's pretty much all there with a good windshield. It had a v8 but the mounts are all wrong and they cut the stock ones out so something needs to be redone there. The rear frame member is bent out slightly from overloading the hitch on something. There is a bench seat that needs redone, some jump seats and a single roll bar. There is a pretty massive bumper on the front that is straight and a home made tow bar on the front that will unbolt. I have tons...
1974 FJ40--For Sale--Charlotte, NC
1974 FJ40--For Sale--Charlotte, NC--SOLD SOLD!! 1974 FJ40 for sale in the Charlotte, NC area. F engine with 4speed. New Mich. LTX 31-10.5-15 on black steel. $2200 obo This cruiser is a project, but it does run. If you can do some body work and tinkering under the hood, you'll have an excellent trail rig. Tranny shifts, 4wd works, brakes work, etc. You'll also get a '76 front disk axle (needs rebuild), front fenders, extra factory roll bar with new paint and oem pads, '78 small cap electronic distributor and igniter, new oem fan, new head gasket, new exhaust gasket, carb rebuild kit, soft half doors, new CCOT Radiator with new hoses and clamps. I think there's a couple of other things...it all goes with the 40...one shot...
Good morning, everyone. Unforseen expenses are forcing me to sell the Cruiser I've built over the past 10 years. Please see the link below for detailed information: http://www.maryooma.com/1969FJ40.htm Asking $14,500 or best offer. Cruiser is also currently listed on ebay, to expire within 4 days or so. Thanks for looking... zayd
I have a 1970 fj40 for sale.New parts :new alt. and battery,new voltage reg.,fuel pump,rebuilt carb,all radiator hoses,belt,oil pan gasget,valve cover gasget,master cyl,rebuilt clutch master,rebuilt all wheel cylinders,new paint org color,hard top seals,6 into 1 header (small leak).I have done so much Im sure there something Im forgetting but this rig is in great shape and runs good. No rust to speak of ,there is a few tiny rust spots under the drivers floor that dont hinder a thing.I bought the rig from my boss who bought it in 76.I tried to get it when I was 16 from him but he wouldnt sell it .I finally got it but have to let it go. I have the full hard top in same great shape.I asking $9500 obo I live in Georgia about an hour and 45...

Thread Filter

Google Preferred
Back
Top Bottom