Cut it back with an exacto knife, round it off, then sand down with emery. I did that to mine and you cannot tell. Its in my build pic somewhere
What have you done to your Land Cruiser this week? (32 Viewers)
- Thread starter IH8MUD
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Cut it back with an exacto knife, round it off, then sand down with emery. I did that to mine and you cannot tell. Its in my build pic somewhere
TEQ
Tigger
This weekend I replaced the water pump on my '78 FJ40 (Uglina). See all the details and pics here in my "fix-up" thread here:
https://forum.ih8mud.com/40-55-series-tech/79672-uglinas-78-fj40-fix-up-thread-8.html#post6588661
Some highlights:
https://forum.ih8mud.com/40-55-series-tech/79672-uglinas-78-fj40-fix-up-thread-8.html#post6588661
Some highlights:
Pulled the leaking intake / exhaust. Seperated it to replace the bad gasket between the two, cleaned it up, new gaskets and no more leaks. Also installed new clutch master and slave.
Bought a not so rusty replacement cab for my H/FJ45 it's going straight to the panel shop to be tidied up. I was going to paint the truck blue(again) but this cab is red, so putting blue on it will be a challenge, maybe I'll go for a nice Hermitage/Burgundy Red instead. Save it looking like a fire truck...
Started it up for the first time in 6 months, 30 seconds on the glow, 3 turns of the crank, no smoke, all good.
Brakes are now all gone, hand brake needs adjusting.
Still deciding whether I should put the Fairey Overdrive kitted box in it when I do the cab swap.
Everytime I look at my truck, I can't help but think I really should do a nut and bolt resto...
Started it up for the first time in 6 months, 30 seconds on the glow, 3 turns of the crank, no smoke, all good.
Brakes are now all gone, hand brake needs adjusting.
Still deciding whether I should put the Fairey Overdrive kitted box in it when I do the cab swap.
Everytime I look at my truck, I can't help but think I really should do a nut and bolt resto...
Loaded it onto the trailer for the 999 mile each way trip to Cruise Moab 2011. Leaving in 10 hours!!!
nick
nick
Found a new tub to replace my badly rusted one. 
Got some new jump seat covers from CCOT. Seats coming in tomorrow...
Mocked up some tube doors
Getting my mind directed toward the first summer with the FJ on the road. Some tube doors to keep the kids in with the top off. Now I need to build another.
Getting my mind directed toward the first summer with the FJ on the road. Some tube doors to keep the kids in with the top off. Now I need to build another.
Had a bikini top made for the new roll cage.
Then went camping/wheeling for the weekend out at Landcruiser Mountain Park
Then went camping/wheeling for the weekend out at Landcruiser Mountain Park
Wired up all the lights, restored wiring harness and new belts, plugs, wires, cap and rotor.
Got my new (to me) jump seats on the FedEx truck. Next stop sandblast, maybe powdercoat.
Had a bikini top made for the new roll cage.
what did the custom top set ya back.....?
Pulled a stump
I used it....to pull a stump....and broke the shear pin in the winch (which happens every time I pull a stump).
I did drag the FJ about 6' along the driveway, pushing the chocks ahead of the wheels.
I used it....to pull a stump....and broke the shear pin in the winch (which happens every time I pull a stump).
I did drag the FJ about 6' along the driveway, pushing the chocks ahead of the wheels.
sourced a 60 series rear diff for the bj42
swapped out a rear hub from the 60 diff to fix the busted hub studs on the 40
made up some quick release mudflaps so i can take them off rather than keep busting them
got a heap of sand and dried mud out of the tyre beads so the swampers hold air
all to get it ready to wheeling next weekend..
swapped out a rear hub from the 60 diff to fix the busted hub studs on the 40
made up some quick release mudflaps so i can take them off rather than keep busting them
got a heap of sand and dried mud out of the tyre beads so the swampers hold air
all to get it ready to wheeling next weekend..
Took it out to my first Cruise Moab.
Nick
Nick
- Joined
- May 1, 2011
- Threads
- 61
- Messages
- 315
- Location
- Sacramento,CA
- Website
- www.landcruiseroftheday.com
Ordered way too many parts from cool cruisers and JT outfitters!!!!l LOL!
- Joined
- May 1, 2011
- Threads
- 61
- Messages
- 315
- Location
- Sacramento,CA
- Website
- www.landcruiseroftheday.com
nicholastheczar said:
I'm jealous...looks awesome!!!!!!
Took it up to Bribie Island with the missus. Wished I had taken my camera on the day instead of the ladies little one, the weather was awesome.
Something blew the Parking Light fuse on way home so I pulled into a car park to check it out, missus took this shot of the sunset
Something blew the Parking Light fuse on way home so I pulled into a car park to check it out, missus took this shot of the sunset
Falco80
Burning dinosaur bones...
Hey DrSlug, your shorty looks to be in great shape! I haven't been down to Bribie yet, but it's on my to-do list. How was the beach condition?
