Builds 1975 Red (green) Money pit (2 Viewers)

[ceylonfj40nut]

In the last pic there is an indent on the female end. Stick a thin pick or screw driver (watch maker type) with thin shank into indent to push in tab, pull wire from other end while shank is seated.

 

[Tommy Shumpert]

This is the rear harness, 7 is the connectors to the main harness by starter.
What are the 2 other circled areas go to?
I know1 is the gas sending and 3 & 4 are the tail and side markers.
What is 2 go to?

 

[Tommy Shumpert]

This is the rear harness, 7 is the connectors to the main harness by starter.
What are the 2 other circled areas go to?
I know1 is the gas sending and 3 & 4 are the tail and side markers.
What is 2 go to?

View attachment 3900496

View attachment 3900497

Someone has to know

 

[pb4ugo]

What color are the wires? The only thing that comes to mind is the reverse light.

 

[LSUfj]

Not certain, but may be the seat belt buzzer for driver seat. WB and green is for the seat belt switch.

 

[Tommy Shumpert]

What color are the wires? The only thing that comes to mind is the reverse light.

Let me look... thanks

 

[Tommy Shumpert]

Little more progress. Window installed. Getting the weather strip on was a pain.

It’s a official Toyota now.. lol

I am a little overwhelmed right now, I have so much to do.

Not to mention all the wiring that still has to be done. EFI, amp, speakers, miscellaneous connections here and there…

Also have to remove the steering box, have to replace seal. Leaking bad. Guess sitting in the heat did a job on it because it didn’t leak before..

 

[RevISK]

It’s too pretty.

 

[Tommy Shumpert]

It’s too pretty.

It's still gonna get dirty... lol

 

[Tommy Shumpert]

Anyone know the bolt size for the rollbar connection here?
I have looked through post and also the "boltlist" posted as well.

thanks

 

[Tommy Shumpert]

Step one of sniper instal. Had a little snafu with the hole size drilled…too big. Welded back in and re drilled with correct size. all good now.
Had to cut the tank cover as well.

Hoping to get the fenders and ambulance doors painted Friday. Then I can tackle the hood.

 

[Tommy Shumpert]

Anyone know the bolt size for the rollbar connection here?
I have looked through post and also the "boltlist" posted as well.

thanks

View attachment 3906732

Anyone know the size?

 

[Jdc1]

Anyone know the size?

If it’s a seat belt bolt- it’ll be 7/16-20. Summit, Amazon, etc all sell. DOT Regulations ugh.

 

[Tommy Shumpert]

If it’s a seat belt bolt- it’ll be 7/16-20. Summit, Amazon, etc all sell. DOT Regulations ugh.

No , it’s the bolts connecting the toolbars together.

 

[Tommy Shumpert]

Ambulance doors down.

 

[Tommy Shumpert]

Fenders too