More progress! Got the wheel well supports welded in with caption nuts. Started smoothing out the top side where my welds are. Also got the seam seal on the bottom side.
I guess I am doing the opposite. I placed the rollbar in correct location and marked the holes then drilled.
So when I flipped over, I placed the braces and marked where the holes needed to go.
Drilled holes and welded capture nut.
Well I finally flipped her over this weekend. Been busy with other honeydew projects. 😂
Got the well supports to weld capture nuts in prime then weld supports in. Strip rest of bottom and fix a few spots.
Then epoxy prime. Flip back over and...
Your sides should end up near flush. I am a half step behind you in this process and am fitting it up and found it really helps to square and determine where to make adjustments with all the pieces loose fitting.