What have you done to your Land Cruiser this week? (50 Viewers)
- Thread starter IH8MUD
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Got my new exhaust put on with the 3FE manifolds I recently installed.
Ended up merging both exhaust manifolds at bell housing then using a band clamp /connection then ran it over skid plate to muffler located behind rear axle, exiting in out the rear on pass side .
Was able to install factory heat shields tight but they fit.
Next up is to install the 90 degree fittings on my oil filter lines. I was able to procure them from "75fj40Toy" who was nice enough to send to me. Thanks again!
Then I will be removing the 32/36 Weber and installing the freshly rebuilt original carb/ air cleaner. Thanks "Pinhead" for your videos detailing the rebuild process.
Am waiting on new throttle cable and fuel line nuts from "ToyotaMatt " before I can install it.
Ended up merging both exhaust manifolds at bell housing then using a band clamp /connection then ran it over skid plate to muffler located behind rear axle, exiting in out the rear on pass side .
Was able to install factory heat shields tight but they fit.
Next up is to install the 90 degree fittings on my oil filter lines. I was able to procure them from "75fj40Toy" who was nice enough to send to me. Thanks again!
Then I will be removing the 32/36 Weber and installing the freshly rebuilt original carb/ air cleaner. Thanks "Pinhead" for your videos detailing the rebuild process.
Am waiting on new throttle cable and fuel line nuts from "ToyotaMatt " before I can install it.
Brian/99uzj100
SILVER Star
Sweet PTO Winch!
I’ve been playing with the Orion since October as time (and skill) allowed. It’s back in seems to be holding gear. So what else do you do? Go play in the slush on a 55* day. 35” mt’s are exciting in slush. Stayed out of the ditch, but it was close.
Picked the kid up from school while the weather held. He’s still not sold on the cruiser, but he lets me have my fun.
Picked the kid up from school while the weather held. He’s still not sold on the cruiser, but he lets me have my fun.
Let me know how you make out in getting one for the fender, I am also looking, was supposed to be getting one from Toyota Matt but he never got back to me
I don't believe @ToyotaMatt has them anymore but try these guys-shipping from Austraila took 5 days to US:
J40 Series Land Cruiser
Spare parts for Toyota Land Cruiser 40 series FJ40 FJ45 BJ40 BJ42 FJ47 BJ45 HJ40 HJ45www.toyotaheritage.com
Please take a moment and read carefully my LAST post in my DATA ID Plates and Engraving service Small Business Store Front Thread now locked and dormant
POST # 125
it may explain a bit why i don't mention or speak of the data plates i so passionately loved to hand craft for everyone so long ago it seams
thanks ..........
DATA I.D. Plates Tags & Engraving Service ( Gallery Briefly Unlocked for Review )
Welcome To the DATA I.D. Plate , Tag & Engraving Service's Small Business Storefront Shop of Rising Sun Mechanical LLC ------- Open For Business ------ If U need a DATA I.D. Plate , Tag & or Engraving Service Please Simply send me a PM...
forum.ih8mud.com
Green Bean
GOLD Star
Finished install of rear heater with electrical. Installed 2 speed switch in dash (bloody knuckles) and ran wire harness back to heater. Also, finished up with double hose brackets from McMaster-Carr and trimmed rear cargo mat to accommodate heater. Thank you to Toyota Matt for parts and technical support.
Green Bean
GOLD Star
Toyota Matt hooked us up with the fog light switch.
thatcabledude
GOLD Star
That’s the “Beam me up, Scotty!” switch
This gonna keep going til you TURN THE KNOB SIDEWAYS!!!
I think it is too late, you cannot unsee the golden shower.This gonna keep going til you TURN THE KNOB SIDEWAYS!!!
fyton2v
SILVER Star
It's been a busy couple of weeks. Replaced some parts, gaskets, and spruced it up a bit.
New water pump, fuel pump and fuel filter, new thermostat and painted the housing. Replace the timing cover gasket and seal. Painted some odds and ends. All this happened because I needed to tear apart the cooling system. Oh, new hoses there. Belts, fan and fan clutch. All the new stuff looks nice.
Also, it was time to do some things on the inside, too. Had the seatbelts re-webbed with new regulators. And I painted the metal seat backs, rear heater, and other grey things.
New water pump, fuel pump and fuel filter, new thermostat and painted the housing. Replace the timing cover gasket and seal. Painted some odds and ends. All this happened because I needed to tear apart the cooling system. Oh, new hoses there. Belts, fan and fan clutch. All the new stuff looks nice.
Also, it was time to do some things on the inside, too. Had the seatbelts re-webbed with new regulators. And I painted the metal seat backs, rear heater, and other grey things.
New stainless Via Overland Metric. What?....It counts. OK, so it wasn’t a banner day. It still counts.
It’s the little things……
Screwing ain't a bad way to spend a day.
fjc-man
SILVER Star
Is that your handy work making the preheat flange? That’ll last longer than the original!
Pura Vida
What an absolute noob
For a second, I thought this was a chat thread lol
come on Airon ?
you know all about my SEMA Spec. Concept Vision FOG and AUX pull switch line up right ?
OEM Toyota Genuine Parts Concept Vision SEMA-Vision After Thought Early Model AUX / FOG, / Auxiliary Lighting / Ditch Lamps / Switch & Service Spec. Repair Harness Pigtail assy. 1968-9/71 - VintageTEqParts.com
OEM Toyota Genuine Parts Concept Vision SEMA-Vision After Thought Early Model FOG, / AUX / Auxiliary Lighting / Ditch Lamps...
vintageteqparts.com
NON-USA OEM FOG AUX Lamps Light Switch & Service Spec. Repair Harness Pigtail assy. LAMP LIGHTS - VintageTEqParts.com
OEM Fog / AUX Lamp Light Switch w/ service Spec Connector Pigtail assy. - Comes with Knob - Pin Wrench...
vintageteqparts.com
OEM Toyota Genuine Parts Concept Vision SEMA-Vision Updated Late Modle FOG AUX , Auxiliary Lighting / Lamps / Light Switch & Service Spec. Repair Harness Pigtail assy. - VintageTEqParts.com
Concept Vision SEMA Inspired Updated Late Modle FJ40 / Bj42 : OEM TOYOTA parts Auxiliary Lighting / Lamps / Light...
vintageteqparts.com
rkymtnflyfisher
Trout Bum
@ToyotaMatt too late sir, that switch is now officially designated as the Golden shower knob. The votes have been tallied.
@ToyotaMatt too late sir, that switch is now officially designated as the Golden shower knob. The votes have been tallied.
The KnOBS of the Many outweigh the Knobs of the few
The KnOBS of the Many outweigh the Knobs of the few
Similar threads
