- Thread starter
- #1,641
Hooked up with the bell housing I was waiting on! That means there is nothing keeping me from trying to get this thing in. Goal is to build the mounts so just the housings.
The only flat place that I have is in the garage. Right now it is resting on its bump stops so I can get it in and out of the garage.
Can I put the engine in while there are no springs in it, or do I have to have it at ride height?
Seems that I will be trying to match the rear pinion angle and that should remain the same whether or not it"s compressed.
I have also heard that the engine needs to be at a 3 to 5 degree angle?
The only flat place that I have is in the garage. Right now it is resting on its bump stops so I can get it in and out of the garage.
Can I put the engine in while there are no springs in it, or do I have to have it at ride height?
Seems that I will be trying to match the rear pinion angle and that should remain the same whether or not it"s compressed.
I have also heard that the engine needs to be at a 3 to 5 degree angle?