Megadoomer

ugh, gross.

730 days from my last day off ,, shop ownership is not what they say it is

All the sensors are either AC Delco or Delphi.

That's a good feeling. This was the time I found out that non OEM sensors are crap. Hopefully you didn't go the same route I went. I had to re-buy the cam sensor, crank sensor, and knock sensors.

I bet you have a handful of axes. You don't seem to shy away from tool ownership. If you don't have skinny jeans, just get fat.

Post in thread 'Megadoomer Build' Builds - Megadoomer Build - https://forum.ih8mud.com/threads/megadoomer-build.685020/post-13848600 My build starts to talk about it around here. I got it from Speedway Motors and it was decently priced. The fan...

I run an aluminum crossflow, double pass radiator in my pig with a LM7 and use the chevy clutch fan. I have done 85 up hill in 115 degree temps with the AC on. I do not worry about cooling with my setup.

Had a good heat not over the top hot, but the true test will come tomorrow.

It's all theoretical at this point. Waiting for a few events to unfold and I should be able to start the build. Basically I am going to put longer coilovers in the front (10" to 14 or 16") Doing trailing arm rear suspension and putting the 10"...

I am hoping to not have any shackles after I am done with the resurrection.

Nice to see you are going to make it to the party. Wish I could be there.

Grey in smedium so I can show the belly I have been working on. 3xl would be nice tho.

I will be there!