Preserving Patina - How To Tips and Tricks (3 Viewers)
- Thread starter wngrog
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #822
This truck has presented an interesting angle. .3/4 of it had good enough paint for CLR then polish and wax. The other 1/4 I did CLR and fluid film. It’s turning out great. It’s a dented mess but there is no chaos.
@Vulkyn you need to check out the axe and shovel bracket on this truck, maybe give you some ideas for yours.
- Thread starter
- #824
This is very simple and functional love it! Thank you.
rex in bama
SILVER Star
My favorite mud thread, though an occasional post veers from “patina preservation” to “extreme neglect”.
for those who have used the Goof off and or straight thinner to remove spray paint with the blue scotch brite..
What’s the best process? Pour on rag and wipe on panel then scrub with scotch brite? Or pour onto scotch brite then scrub?
Spray onto panel with sprayer? Then scrub?
So far I’ve just been pouring on a rag and scrubbing.
What’s the best process? Pour on rag and wipe on panel then scrub with scotch brite? Or pour onto scotch brite then scrub?
Spray onto panel with sprayer? Then scrub?
So far I’ve just been pouring on a rag and scrubbing.
I had the best luck with these two approaches:
Or pour onto scotch brite then scrub?
Spray onto panel with sprayer? Then scrub?
Thought I’d throw a before photo:
Driving out at the farm after the rains.
Before and after clr plus fluid film (fluid film was quick to apply so went with that for now, eventually I’d like to buff/wax).
Driving out at the farm after the rains.
Before and after clr plus fluid film (fluid film was quick to apply so went with that for now, eventually I’d like to buff/wax).
Last edited:
It's amazing how much that brought the color out!
Yeah absolutely, granted the photo hides a lot of the imperfections. I’m really happy with how this turned out. It honestly blows me away! Interestingly, this truck had been resprayed at least 25+ years ago, so I recovered a non factory paint job. I was nervous how the cheaper paint mind hold up.
- Thread starter
- #835
Doing a little magic with an old re-paint job.
Before/After
B/A
Before/After
B/A
phishtaco
Cincinnati
My quick attempt with some clr and a quick buff. I think there is room for improvement. Now to decide to keep or sell. I’ve owned it for 19 years. Befores
phishtaco
Cincinnati
- Thread starter
- #838
Nice!
cruiserkev
3 decades in the same FJ40
Not much patina here but I decided to try Nolens Fluid Film treatment on my tired, oxidized 2004 rattle can paint job and it turned out great! Thanks wngrog! 
rex in bama
SILVER Star
If you’ve moved on to fluid film, but still have a fair amount of boiled linseed oil, know that it works wonders on old whiskey barrels. A local brewery was liquidating (RIP Orpheus), and I picked up a used Woodford Reserve barrel (they were aging stout in) for cheap. Now a cabin cocktail table with patina!
