- Thread starter
- #261
Where did you source the spare tire rod clips from? I need a set of those.
Also on the crush sleeve I did not need another one, but if you need to replace it you will need to remove the diff and set up the whole gear-set.
Clips I purchased from Partsouq as my regular parts guy is on hiatus.
As for the crush sleeve, the FSM shows it can be replaced and torqued to spec without removing the rear diff cover and messing with setting up the gearset. I made a PDF of the few pages that outline the procedure, looks a bit tedious, but within my capabilities. If I'm reading this wrong and you do need to go through the whole painting, tighten, inspect, etc procedure, then this is something I should probably have a pro address.