ARCHIVE 80 Series - Did you know? (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Can you toss some to me as I'm driving by tomorrow afternoon? Around 2-2:30 pm.

Come on by. Mulholland/Valley Circle exit off the 101 ;)

plugs.jpg
 
Just order from @beno, guy provides a hell of a service to the community. Save the time of going to the dealer, get them delivered to your door and support a cruiser guy. Can't lose.
 
The wire isn't there for all years. I know the 97 doesn't have the factory harness.
 
DYK:
To check your drive shaft U-Joints or Yoke wear as well as when you grease them, you should do it with your drive line UNLOADED.

Have the truck in Neutral, wheels chocked on both sides, and maybe even set the e-brake. This will allow the drive line to be loose and you can feel all the slop. it will also allow the grease to go into all areas of the U-Joint and Yoke because the tolerances are still open and allow a pathway for the grease.
 
The wire isn't there for all years. I know the 97 doesn't have the factory harness.

^this, my 97 doesn't it have it either

Edited because my fawking iPhone thinks it knows what I wanted to say :rolleyes:
 
Last edited:

Users who are viewing this thread

Back
Top Bottom