ARCHIVE 80 Series - Did you know?

[NLXTACY]

Can you toss some to me as I'm driving by tomorrow afternoon? Around 2-2:30 pm.

Come on by. Mulholland/Valley Circle exit off the 101

 

[Tapage]

They run about $2.04 each.

Onur .. Can you share part number .?

 

[TLC Norway]

Fun thread. I don't think there's anything similar four the 60s?

 

[OGBeno]

Onur .. Can you share part number .?

90341-18021

 

[scottryana]

Just order from @beno, guy provides a hell of a service to the community. Save the time of going to the dealer, get them delivered to your door and support a cruiser guy. Can't lose.

 

[bloc]

Especially now that he is starting a small business..

 

[NLXTACY]

Especially now that he is starting a small business..

?????

 

[gofast]

Dyk there is already wiring at the rear of the fj for a third interior overhead light?

Where?

 

[BamaPaul]

It's tucked in the DS D-pillar. It is a 30 minute job and gives good light back there, especially when you upgrade to leds.

 

[BILT4ME]

?????

Apparently...Check out his new sig line in post #344......

 

[NLXTACY]

Apparently...Check out his new sig line in post #344......

No sigs on the phone.

We PM'd

 

[DOCBG]

It's tucked in the DS D-pillar. It is a 30 minute job and gives good light back there, especially when you upgrade to leds.

Can you post a pic?

 

[BamaPaul]

https://forum.ih8mud.com/threads/rear-cargo-light-install-erg80-style.518809/page-3

 

[Dissent]

Dyk there is already wiring at the rear of the fj for a third interior overhead light?

Near the hatch?

 

[BamaPaul]

Near the hatch?

Check the post just above your last one.

https://forum.ih8mud.com/threads/rear-cargo-light-install-erg80-style.518809/

 

[TomH]

The wire isn't there for all years. I know the 97 doesn't have the factory harness.

 

[BILT4ME]

DYK:
To check your drive shaft U-Joints or Yoke wear as well as when you grease them, you should do it with your drive line UNLOADED.

Have the truck in Neutral, wheels chocked on both sides, and maybe even set the e-brake. This will allow the drive line to be loose and you can feel all the slop. it will also allow the grease to go into all areas of the U-Joint and Yoke because the tolerances are still open and allow a pathway for the grease.

 

[NLXTACY]

The wire isn't there for all years. I know the 97 doesn't have the factory harness.

^this, my 97 doesn't it have it either

Edited because my fawking iPhone thinks it knows what I wanted to say

 

[BILT4ME]

^this, my 97 does it have it either

HUH???

 

[NLXTACY]

HUH???

Serious. Found it out way back when that thread started. I had to run my own wiring.