Hi
In the process of finalizing a gasket for the LVs rear boot handle and door handles.
We 3D scanned the actual Handle and the 4 outer door handles and have designed gaskets to replace the factory gaskets.
The final design will have the exact beveled look around the outside of the handle as the factory gasket.
After fitting the prints today minor adjustments are being made to make it as perfect as possible before we start producing them.
The idea will be the sell a set which will include the following :
3D printed Rear hatch handle gasket x1
3D printed outer door handles gasket x4
The outer doors handle gaskets are made up of two parts for each handle.
So in fact you will be receiving x9 gaskets in total.
Planning on doing runs of 20 sets at a time to bring the cost down.
Please have a look at the prototype which is white and will be in black when finished. I should have the final sample by Sunday next week which we will test fit and I will share pictures, material spec sheets and prices then.
In the process of finalizing a gasket for the LVs rear boot handle and door handles.
We 3D scanned the actual Handle and the 4 outer door handles and have designed gaskets to replace the factory gaskets.
The final design will have the exact beveled look around the outside of the handle as the factory gasket.
After fitting the prints today minor adjustments are being made to make it as perfect as possible before we start producing them.
The idea will be the sell a set which will include the following :
3D printed Rear hatch handle gasket x1
3D printed outer door handles gasket x4
The outer doors handle gaskets are made up of two parts for each handle.
So in fact you will be receiving x9 gaskets in total.
Planning on doing runs of 20 sets at a time to bring the cost down.
Please have a look at the prototype which is white and will be in black when finished. I should have the final sample by Sunday next week which we will test fit and I will share pictures, material spec sheets and prices then.