Gonna be a shame to cover that up with the floorboard.
What have you done to your Land Cruiser this week? (38 Viewers)
- Thread starter IH8MUD
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Well, I do have to modify my tunnel…and I just so happen to have a sheet of 3/8” plexiglass.
Look into Vacuforming!Well, I do have to modify my tunnel…and I just so happen to have a sheet of 3/8” plexiglass.
I've done a lot of vacuum forming of plastics in my trade. I'd not recommend plexiglass for a trans tunnel. Plexiglass is notch sensitive and can/will crack with an impact. I'd choose Lexan over plexiglass. Although Lexan is hygroscopic and should be dried before molding to avoid bubbles in it. Although a window in it would be cool... although nearly impossible to keep clean on a 40 that doesn't live in a showroom. It certainly could be done if the correct procedures are followed.
Damn that's cool!
Michael B
SILVER Star
Did you make that? It’s very nice!
South Texas 97
GOLD Star
New front bumper and reinstall trans cover and gas tank.
trans cover and gas tank
desmocruiser
SILVER Star
A few Pre GSMTR mods! MetalTech Family cage with single stage gray paint over epoxy primer.
desmocruiser
SILVER Star
A few more! Rear QTR protection!
desmocruiser
SILVER Star
Extended the sliders and added the SOR full bikini top!
desmocruiser
SILVER Star
Pre Trip mods that allow you to do more of this!
How is the footwell clearance with the cage? That’s one thing I always wondered on one.
desmocruiser
SILVER Star
I want to see the next picture
Dropped by to say hi to our 37th.
Last edited:
CondeCruiser
SILVER Star
Got the soft top bows on yesterday, rebuilt the carb today.
Yes I made it. I have made most of my living over forty years making and selling miniatures.
Imagine what the frustration is to drop one of the parts on the floor.
I like to take a few day off every once in a while to go tinker on my 40 so I can drop larger things.
I pulled the rear driveshaft yesterday.
So far I haven't lost any parts.
desmocruiser
SILVER Star
I have driven and been in several and had never noticed any interference or inconvenience, however when we initially tacked mine together to confirm clearance of the doors, window cranks, hardtop bolts etc. I became a little concerned, especially since this is a 78’ and later 40’s have slightly wider doors.
After trail riding all weekend, getting in and out what seemed like 100 times, I never adjusted my driving position or felt it changed the way I got in or out or operated the clutch. Visually tight yes, but not functionally in any way I noticed.
Everytime I see one of those cages I want one a little more. MetalTech makes such a good cage... I want one.
Last edited:
