those kong bumpstops are no match for the chewing force of a wiener dog
What Did You Do with Your 80 This Weekend? (51 Viewers)
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Outsane
Supporting Vendor
@Overlanderson You got a mean wiener
he identifies as an a$$ hole lol
Outsane
Supporting Vendor
Seems a little inverted, enjoy
AC stopped working on the 80 series, and after doing some searching on the forum... I removed the AC amplifier and dissected the circuit board to find evidence of water... After some electronics parts cleaner and toothbrush action the unit was reinstalled and working great again!!! Thanks to this incredible community. Good to go for the summer again!
100% & a tip
To clean the pins I put the bolt in a socket whilst in an impact / drill driver to spin them up and hold some fine grade steel wool around the sliding section. Polishes them up real good ready for the slide grease
banieldowen
SILVER Star
You mind sharing some links that helped you? When you say stored wiring do you mean completely?
MinorESalas
Diógenes De Sínope
I cleaned and washed the entire floor. Everything is like new now. Then, a bit of Costa Rican Sun!
Another Toyota with terrible paint was purchased. Picked up from previous owner who stored it in a garage since 2011. It does drive but the throw out bearing is shot, which is an engine out service on these Alltracs. Going to "baseline" it while it is out with new seals, gaskets, hoses, etc. Already tried to get the purple tint off but it must be original to 1991 because my usual steamer technique didn't work. It's baked on there!
suzuguru
SILVER Star
Replaced both front window regulators with motors. Mine were still working but were extremely slow and would occasionally stop altogether. I went with the AISIN from Rock Auto. They definitely work much better now, but I'm not impressed by the speed at which they go up or down. As you can see in the pictures, the driver's side was particularly nasty.
Do you have a part number for those?
suzuguru
SILVER Star
Much appreciated
Buddy and I started the cargo/drawer system for my 1997 
Drawers will be 500lbs sliders…when finished, it’ll be sanded and stained, and then carpeted; the wheel wells are also being enclosed for additional storage. Drawers are custom with dividers.
Drawers will be 500lbs sliders…when finished, it’ll be sanded and stained, and then carpeted; the wheel wells are also being enclosed for additional storage. Drawers are custom with dividers.
I got one too, mounted in the same spot, zip tied to fuel lines.
22 clicks up for me with 90% underdrive and 35" tires
Moved the rack over to the 80 from the LX470. Had to measure, drill new holes, get longer bolts, manhandle it into place by myself 
.
. 
Fj80oregon
GOLD Star
Another one going back in. Marry up the tranny in the morning and get it installed hopefully.
