Somebodyelse5
16124-75030
I made my scanguage light up up less and match the dash a little better...
Before:
After:
Before:
After:
Last edited:
What Did You Do with Your 80 This Weekend? (100 Viewers)
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
How’s it going ? So far so good for me!
Very nice. I like that display!. Had to go with the green on my panel to halfway match the Toyota green interior lol.
mehbohdi
SILVER Star
Check this out friend of a friend ask if I wanted a Landcruiser catalog and I said yes, of course. So old, that only had FJ80 and promise of parts to come in near future. And bonus vintage sticker inside.
Have a great day
Have a great day
AgentOrange
TLCA #28372
Got my 37s on. Flexed it just enough on the planter to see where I need to trim on the rear fenders just a touch. Excited to get it right
@AgentOrange Which lift are you running? Are you planning on using any bumpstop extensions? I'm at a similar point and have seen a few different paths to accommodate for tire clearance F/R.
Thanks,
Jeff
AgentOrange
TLCA #28372
These are Dobinsons VT heavy springs, 3" rear, 3.5 front. I just have the bumpstops dropped an inch. On the 315s with no bumpstop extensions I didn't rub almost ever, but these are wider and taller. Definitely recommend a heavy duty rear stabilizer and heavy duty links. It's downright terrifying without the bar with weight in it, and my stock links worked for maybe half a trip before letting go.
Replacing some maintenance items, replaced vacuum lines and installed the CDL switch.
Cough cough…. Fuel pressure regulator…
Caught cough...throttle cable...
Cough cough…. Thanks lol
Cough cough…. Thanks lol
Laid down Kill Mat and 150 mil sound deadening foam mat. Once new carpet come is will pull the front seats and complete the insulation and sound deadening. Plan to pull the headliner as well.
I'm not finished. I need to shorten up some wires to my rock lights. Make the wiring look better than it currently does, and wire in the the power to the panel.
Where did you tie in your power to the panel?
Somebodyelse5
16124-75030
It’s so satisfying to install that stuff. Looks good!
Played rescuer to a jeep
Those headlights are me pulling with the winch
Those headlights are me pulling with the winch
Finally! After a 3 year hunt I scored a NOS gauge off eBay and the correct pod from another member.
Thanks again @S.CarolinaFZJ80!
Thanks again @S.CarolinaFZJ80!
EIther that's a bad photo angle or the needle is way off. I replaced my TRD boost guage for that exact reason. The needle should be centered on "0" right now.
Chasing some driveline vibe in the rear. and noticed there was some slop in the driveshaft. Replaced with a new one this afternoon from Boch Toyota South. Haven't had a chance to test drive yet. Stupid work....
2KCruiser
Everything 2KRacing, practically live here
Maybe he lives in a negative atmospheric pressure environment.
