- Thread starter
- #81
Knuckle cleaning, inspecting and recondition also went well, nothing remarkable. Just standard wire brushing and marine greasing of bare metal. Axle bushing and needle bearings cleaned up & inspected nicely.
New seal and greased up ready to go:
Packed the bearings then readied axle hub for install. Being careful not to over fill the cavity with grease, which would retain excessive heat without some air space:
New seal and greased up ready to go:
Packed the bearings then readied axle hub for install. Being careful not to over fill the cavity with grease, which would retain excessive heat without some air space:
Last edited: