Motor Mount Question (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Goldbug

SILVER Star
Joined
Apr 14, 2020
Threads
29
Messages
587
Location
Rhode Island
I'm missing one of the motor mounts in my '78 with a swapped engine. It looks like the OEM replacement part is 12371-60010 Dealer Website. Can anyone confirm if this is just for 1 of the rubber discs? $22.70 seems steep even for OEM prices for just a small piece of rubber. Wondering if I've got the part no wrong.

Also, any advice on getting it on is welcome. I believe all the other motor mounts are original.
 
Last edited:
First pic shows missing one. Drivers side rear.

C380001F-0147-446F-BB81-B03F3F503304.jpeg


175C579B-BA0D-4368-A73B-5DED545710B1.jpeg


99C3DCD0-A01F-4B84-9568-851D385D39B4.jpeg
 
that motor mount (last pic) is shot! bet the motor isn't even connected to that anymore, just sitting on it. pretty sure cruiser outfitters has a good aftermarket part, get both sides.

not sure about the disc part but $22 doesn't seem bad... cruiser outfitters could probably take care of you there too. also think it is a metal core with a rubber overmold but not sure, they are tough and last forever.
 
that motor mount (last pic) is shot! bet the motor isn't even connected to that anymore, just sitting on it. pretty sure cruiser outfitters has a good aftermarket part, get both sides.

not sure about the disc part but $22 doesn't seem bad... cruiser outfitters could probably take care of you there too. also think it is a metal core with a rubber overmold but not sure, they are tough and last forever.
Thanks, guess I’ll give Kurt a call
 
If you’re going to replace one or two mounts you might as well replace them all. No point in going halfway.
 
If you haven’t done the body mounts you could get them while you are at it....relatively inexpensive and will improve ride quality quite a bit.
 
for the 2 rear ones, get new bolts and nuts and washers,
 
If you haven’t done the body mounts you could get them while you are at it....relatively inexpensive and will improve ride quality quite a bit.
I could use an improvement in ride quality. Might have to bite the bullet on that. Think I’ll do motor first. @3_puppies I just ordered the full kit from SOR including hardware. Cruiser Outfitters and Cruiser Corps were both out.
 
Last edited:
Got the two rear mounts in. One of the new front ones doesn’t look right to me, so gonna call SOR when they open up tomorrow before putting that in. Was a good night of wrenching and watching basketball to the wee hours on Friday. Passenger side bolt was pretty beat up.

C5C25AFF-EB61-451E-A5EA-A9B9A61A9742.jpeg


9856C721-C4A8-49FA-A462-CDDEB0D69628.jpeg


FA4BD318-144E-45E3-845D-80A820F92252.jpeg


DB384ABA-CA25-4A45-AD37-11CA7C539E09.jpeg
 

Users who are viewing this thread

Back
Top Bottom