Really not much different than just removing the bin except the headlight shows all the mounts and adjustments.
This is an FJ25 minus the chrome rings and bars Infront of the radiator.
I figured it out so I wanted to circle back and let folks know in case they are interested in using this switch, especially in a negative/ground trigger configuration.
Since I was using a negative/ground trigger, I had to deviate a bit from...
I measured a new rear floor and mid bed panel (real steel) and they both were 40 7/8"
From this image it appears that the factory dimension is 1015mm which is more like 40" but as you found they are typically closer to 41".
Respectfully, you can’t believe everything you see on Fox News. I’m not sure how much you know about the Canadian parliamentary system, but Trudeau was the leader of two consecutive minority governments, which means that the government is formed...
Definitely welded by PO. All components of the frame are rivited togther from factory with the exception of a couple brackets in the front frame horns AFAIK