- Thread starter
- #3,281
Would you also happen to have a link to directions on how to wire this thing up to the 8274?
Yup:
Wiring an 8274 + Albright
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Would you also happen to have a link to directions on how to wire this thing up to the 8274?
Johnny, what size intercooler are you able to fit? I'm thinking I might go larger when I get back.
You gonna groove them?
Looks like we have the same wheels. What's the maximum psi you're comfortable putting in the tires with those wheels?
Nice job. That is a lot of back breaking work!Step 6: Install all nuts by hand and pound them home with an impact. Note the gap between the upper half and lower half of the rim. Tighten the outer half of the rim evenly so the tire and insert seat properly. Start:
End:
Step 7: Put 10psi of air into the tire and check for leaks.
Step 8: Torque all nuts, in a star pattern, to ~100ft/lbs.
Step 9. Repeat steps 1-8 at least 3 more times and you get a set of mounted tires:
Hope this helps someone, someday.
I'm only asking because if i remember correctly, you can only go up to 30 psi on those wheels.I never put more than 25psi in these, but that's because I don't run them on the street. 99.99% of the time they see between 0 and 6 PSI.