MatthewMcD
SILVER Star
- Thread starter
- #41
That's my concern. But, based on the vast knowledge here and my limited knowledge, I'll go ahead and assemble it and see.
I'll check back in after, it'll probably be this weekend.
Tie Rod End Replacement Woes (1 Viewer)
- Thread starter MatthewMcD
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I'll check back in after, it'll probably be this weekend.
MatthewMcD
SILVER Star
- Thread starter
- #42
Got after it today. I made a "vice" to set the shims after gently milling out the tapers with a 7 degree reamer. It cleaned up all of the rust and got it back to round. Using the vice I set the shims.
Then I set the TREs and tightened them up. They sank in and are flush with the top of the castle nuts.
Tomorrow I'll reposition the truck so I can set the alignment and get her back on the road.
More to come. Thanks all.
Then I set the TREs and tightened them up. They sank in and are flush with the top of the castle nuts.
Tomorrow I'll reposition the truck so I can set the alignment and get her back on the road.
More to come. Thanks all.
MatthewMcD
SILVER Star
- Thread starter
- #43
Alignment complete.
She drives in a straight line now! (Before the steering was so loose it was more like driving a school bus and the steering wheel was merely "suggesting" where to go.)
While I was laid up from my surgery during all this I took the time to refinish the hard top. She's nice and shiny and water tight now.
Thanks again to everyone who contributed to this thread.
Matt
She drives in a straight line now! (Before the steering was so loose it was more like driving a school bus and the steering wheel was merely "suggesting" where to go.)
While I was laid up from my surgery during all this I took the time to refinish the hard top. She's nice and shiny and water tight now.
Thanks again to everyone who contributed to this thread.
Matt
