Finally I have a few hours to assemble, maybe I'll get it back together tonight.
Now, what are the two smaller o-rings for? Large one goes on idler shaft.
View attachment 1085375
Medium is for the outside of the speedo "bullet"
Small one doesn't get used.
The aluminum crush washers are for the fill/drain plugs.
Georg @ Valley Hybrids
Perhaps this was meant only in the context of rebuilding the transfer case, but in case anyone is wondering, the small o-ring is actually for the reverse gear idler arm shaft which comes through the side of the transmission case. The small O-ring goes between the case and a plate washer.
Last edited: