hey ya’ll. I’m at a total loss here.
I got my T- case rebuilt and after a very long weekend got it back in the truck. I wanted to wait to stake the nuts till i got it in and running for a short bit to confirm i didn’t make a major error…
When i go to stake both F/R I noticed that they don't seem to be far enough on to stake properly.
and yes I did already torque these to the 94lb spec.
And the final part which i feel like is probably related…. I can’t fit the rear driveshaft. Its seemingly too long now….
so close….yet so far…..
I got my T- case rebuilt and after a very long weekend got it back in the truck. I wanted to wait to stake the nuts till i got it in and running for a short bit to confirm i didn’t make a major error…
When i go to stake both F/R I noticed that they don't seem to be far enough on to stake properly.
and yes I did already torque these to the 94lb spec.
And the final part which i feel like is probably related…. I can’t fit the rear driveshaft. Its seemingly too long now….
so close….yet so far…..
