Hey y'all,
I have looked around this site a few times while trying to find some answers and finally choose to make an account and ask myself.
First, What is the desired idle on a 87 FJ60? (I ask because when I adjust the idle speed to low (below 700RPM) after driving and stepping on brakes while coming to a stop in neutral the truck will shut off.
Second, I am thinking about doing a desmog and want to get a new carb that I can adjust the jets, what is the best (cost considered) carb for this? I was considering running a snorkel for the intake to get more fresh air, any advice?
Third, Where is the best place to find parts?? I am looking for either a new power steering fluid reservoir, or just the seals to fix a leak, I am looking for a place for new struts, (rear passenger is sagging would prefer to find a way to lift it a couple inches if anyone has advice) also I am looking for possibly a new starter. Overall I am looking for a legitimate, cost efficient, reliable place to find parts.
Fourth, What gauge sheet metal is preferred to repair rocker panels? Any advice when doing this repair...
I am attempting to do the work in the spring when I get out of school, so not to time sensitive but sooner the better.
Thank you for the help!!
I have looked around this site a few times while trying to find some answers and finally choose to make an account and ask myself.
First, What is the desired idle on a 87 FJ60? (I ask because when I adjust the idle speed to low (below 700RPM) after driving and stepping on brakes while coming to a stop in neutral the truck will shut off.
Second, I am thinking about doing a desmog and want to get a new carb that I can adjust the jets, what is the best (cost considered) carb for this? I was considering running a snorkel for the intake to get more fresh air, any advice?
Third, Where is the best place to find parts?? I am looking for either a new power steering fluid reservoir, or just the seals to fix a leak, I am looking for a place for new struts, (rear passenger is sagging would prefer to find a way to lift it a couple inches if anyone has advice) also I am looking for possibly a new starter. Overall I am looking for a legitimate, cost efficient, reliable place to find parts.
Fourth, What gauge sheet metal is preferred to repair rocker panels? Any advice when doing this repair...
I am attempting to do the work in the spring when I get out of school, so not to time sensitive but sooner the better.
Thank you for the help!!