What have you done to your Land Cruiser this week? (39 Viewers)

[Cal40]

Seat covers, roll cage, and wheeling.

Fast Eddy,

Did you formerly have bows on your 40? Saw one just like this driving down winchester a few weeks ago with soft top bows. Real nice.

 

[Waterboy]

Thanks!

Nice bends! What are you using?

Eastwood tools and Brake lines from Advanced Auto Parts. They came out a lot better then expected. Looking at redoing the ones I already did (axle's and down the frame).

Thanks again

 

[juanchogaviria]

Got my dad to drive the 40 and parked it in the spot where i´ll be building my garage!

 

[Fast Eddy]

Fast Eddy,

Did you formerly have bows on your 40? Saw one just like this driving down winchester a few weeks ago with soft top bows. Real nice.

Soft top bows? Are you sure? I was on Winchester a few weeks ago coming and going from getting my dash box installed (so there's another thing I've done to my cruiser lately).

Dash Box Install by The Dashman, Mark Vickers

 

[kenichols29]

Went wheeling over the weekend. Had a great time.

Video 1

Video 2

 

[oregonfj]

Very nice! I will have to use that pic when I restore my 8274. Did you do that or did it come that pretty? Nice bumper also, where did ya get it?

I splurged on a new 8274-50. The bumper is one I built a few years back out of 2x5" rectangle tube, I just modified it to accept the winch and repainted it.

 

[jmdaniel]

Got my new (to me) rear step sandblasted and powder coated, going to slap it on this weekend!

 

[Blue77FJ40]

78fj40mg, time too flip your bezel.

 

[FJ40Jim]

Tech:
Removed ticker fuel pump beside tank, replace with toyota low pressure pump in tank. No more boil fuel in the suction line.
Changed oil & filter, lubed all 21 grease fittings.

creature comforts:
Reinstalled the repaired radio. Got tunes again!
Swapped in a reman AC compresor. Chillin' again!

 

[73tlcv8]

got the 3fe running

Finished the exhaust and some misc stuff. Took it for a ride for the first time in two months.

 

[kenichols29]

Mounted the hindges on my custom tailgate that me and my grandpa built.

 

[Hogester79]

finished carpet install
finished install of full autometer gauge set
finished all wiring except power to amp for rear speaker set (6x9's in boxes)
redid all wiring for electronic speedo sensor and re routed all wires from under the car to clean up cabin

 

[oregonfj]

Tried out the new winch getting to the gold claim

 

[CondeCruiser]

Finished up my SOA and drove it for the first time in 6 months!

 

[ColonelMustardFJ40]

What animal is that in the left foreground of your bottom picture?? Great 40 BTW.

 

[CondeCruiser]

What animal is that in the left foreground of your bottom picture?? Great 40 BTW.

Don't see an animal?.. There is a 4speed and tcase along with an axle housing next to the garage.

 

[JohnnyC]

new sticker...now there's no confusing what engine is in there

its a bit larger that I thought it would be...need to get correct measurements some time

 

[oregonfj]

What animal is that in the left foreground of your bottom picture?? Great 40 BTW.

That's an old fat blue healer

 

[yanikins]

Ordered new front indicators, removed front guards, the panels above them and the front panel, stripped the paint off them and cut out the rust, halfway through welding in new plates. Disassembled, cleaned and rebuilt the wiper switch. Changed tie rod ends. Welded up some cracked braces on the tray. Ripped out the over head console. Ordered a second hand speedometer.


All right for the first week...

 

[FouadHafeez]

Wheeled the bloody hell out of it!

About @#$%ing time, too! It'd been building and building and building and building...for FAR too long.