What have you done to your 100 Series this week? (63 Viewers)
- Thread starter SHUSH
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Took mine to Slee Off road. Had LX470 suspension converted to OME lift plus Slee step sliders installed. All fluids changed along with T's replaced. Wheel bearings repacked, Also new plugs. Should be good to go for a few years.
Who do you use? I am in SE PDX and am looking to powdercoat my LX wheels.
Do they take all the AHC crap off or do they drain it and just cap it off?
Slee does a top of the line job. Remove everything even the dash lights and replaces the console controls with a nice holder that my sun glasses now reside. I drove from Las Vegas to Golden Colorado to have Cristo do the work on my 2005. Worth the 12 hour drive.
Redid my aux battery wiring in preparation for the ARB compressor install. Added military terminals, fuse box, and used the warm license plate mount as a circuit board tray.
Finally got my MetricTLC key cut to my VIN.
And added my most important mod to date.
Finally got my MetricTLC key cut to my VIN.
And added my most important mod to date.
jonharis
Adventure Imports
Improving on the Slee step sliders for 1" body lift. Added 2" .25wall box tubing to replace C channel and thicker brackets to prevent bending. Should be mo bomber now and the same height as pre BL.
PM sent
Can you tell it's not factory?
Cheap shot IMO. Was it a secondary offense?
I told him he can't give me a second offense as a first offense...I threw these on for pictures and peeling them off after. It's a $125 ticket, I'll spend a day and battle it.
Uhh...WISHED I HADN'T BOUGHT AND INSTALLED DOUG THORLEY HEADERS...TWO PAIRS IN FACT!
what fog lights are you using? I thought about grabbing some of the X6 LED fogs TRS has on the site, but I'm afraid they'll be too big for that hole.
You can take them out of the housing and they are much smaller. I'll try a pair and post pictures. I built xenon fog lights last year, just never installed them until now. 3700K 35W.what fog lights are you using? I thought about grabbing some of the X6 LED fogs TRS has on the site, but I'm afraid they'll be too big for that hole.
Last edited:
If you remember to, cool. I was about to order a HID kit to replace the cheap ddm junk ballast and I was looking around. no way am I paying $85 for the arb kit.
edit: what fog light housing did you use? I forgot I have a set of the matchbox projectors NIB in my garage.
If you remember to, cool. I was about to order a HID kit to replace the cheap ddm junk ballast and I was looking around. no way am I paying $85 for the arb kit.
I used the ARB housing. Soak the sealed beam in gasoline to take it apart. Hole saw and your done!
Looks good. Thanks.
Cracked welds on the first pair and now failed smog pass on the 2nd pair.
