What's the dial to the left of the wheel? The button looks like RCSA, but its the dial for an OE locker? On a 03+? 105? Oh, and nice TP BTW, lol.
What have you done to your 100 Series this week? (58 Viewers)
- Thread starter SHUSH
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
hoser
SILVER Star
100 TD's CDF-25 fits as well. But yeah, US market armrests would be in the way.
https://forum.ih8mud.com/showpost.php?p=348763&postcount=9
https://forum.ih8mud.com/showpost.php?p=348763&postcount=9
Last week actually: Completed my 2nd 90K PM with many parts including a new radiator. Also added a custom 19mm steering shaft spacer to go along with the 1" body lift.
That dial is for the rear diff lock. Its standard in European spec models.
The problem going with a bigger fridge was that it then becomes less like a centre console and more like a fridge. Its just for day trips to keep drinks cool and maybe a sandwich but its nothing more. The CDf-25 makes resting your arm and changing gear unnatural as it sits quite allot higher.
The problem going with a bigger fridge was that it then becomes less like a centre console and more like a fridge. Its just for day trips to keep drinks cool and maybe a sandwich but its nothing more. The CDf-25 makes resting your arm and changing gear unnatural as it sits quite allot higher.
Replaced A/C evap cover and used FIPG to stop condenser leak. Fingers crossed....
Checked the A/C drain was working properly also.
While I was in there installed valve for BG Clean and ran a can through. What drained out wasn't that bad but it smells better.
Checked the A/C drain was working properly also.
While I was in there installed valve for BG Clean and ran a can through. What drained out wasn't that bad but it smells better.
perrobravo
SILVER Star
1. Installed Air Lift bags to help with rear sag when fully loaded
2. Added cabin air filters in my '03...which never had them or the slot to put them in. Followed the instructions here:
https://forum.ih8mud.com/100-series-cruisers/501701-cabin-air-filter-conversion-lc100-lx470-7.html
Before
During
After
2. Added cabin air filters in my '03...which never had them or the slot to put them in. Followed the instructions here:
https://forum.ih8mud.com/100-series-cruisers/501701-cabin-air-filter-conversion-lc100-lx470-7.html
Before
During
After
So wicked looking!
I was cleaning my truck this week and I notice these junks are coming out of my AC went (its like a sponge) any ideas?
Most likely foam insulation from the duct worm. Either that or you hit sponge bob.
Bloomer
SILVER Star
I have the same annoying thing happening with my 06. Watch the stuff when it gets in your carpet. If smeared, my experience is that it leaves a stain like residue that's difficult to remove.
thank you guys
i notice there are more of the foam coming out from driver side , is there any way i can look inside the vent?
i notice there are more of the foam coming out from driver side , is there any way i can look inside the vent?
thank you guys
i notice there are more of the foam coming out from driver side , is there any way i can look inside the vent?
Harbor Freight has this LCD screen inspection tool for around $80....it looks like a scope with a light and a camera. I have always wanted one, and so have you! Perfect time to get one.
http://www.harborfreight.com/digital-inspection-camera-67979.html
Last edited:
APKhaos
Unfixing the unfixable
Before you pull that trigger, take a look at the Whistler scope at Costco. Much better camera and light source, but more important a camera head small enough to go down a spark plug hole (which the HF is not). Around $140 last time I looked, and a decent quality piece. Rigid See Snake is even better but north of $200.
My wife and I rebooted both CV shafts last night... I would rather mess with a SFA anyday! LOL
