bobm
WTF, WTF, WTF!!!!
KY
rear body mounts (1 Viewer)
- Thread starter xtiaan2000
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
tucker74
Moderator
Yup - lube and go! Should probably put the foam on the underside of the transmission cover first, unless you wanna be pulling it back off when you remove the cover
- Thread starter
- #3,083
The boot proved to be no problem. Silicone and done.
Everything out and saying goodbye to my beautiful floors!
Was not unhappy with how this stuff laid out.
Got all back together
Took it out for a drive and at first was not too amazed and then I started to hear how loud the gaps were in my door and how a little whistle was actually a howl. Then took my friend for a ride and the benefits were confirmed. I can’t hear a pin drop but now I can talk hear the person in the back seat. I have reached the ‘books on tape’ ready vehicle!!
Everything out and saying goodbye to my beautiful floors!
Was not unhappy with how this stuff laid out.
Got all back together
Took it out for a drive and at first was not too amazed and then I started to hear how loud the gaps were in my door and how a little whistle was actually a howl. Then took my friend for a ride and the benefits were confirmed. I can’t hear a pin drop but now I can talk hear the person in the back seat. I have reached the ‘books on tape’ ready vehicle!!
- Thread starter
- #3,084
I still haven’t yet addressed the exhaust yet either. So it will be even more quiet with that accomplished. Got a strategy, but am waiting to get some mentorship before I order the bends and such. Gotta guy though, I am going to do it myself this time. That is, the aft end of the system.
So these were the steps
Sandblast
Epoxy primer
Two coats of single stage paint
Two coats of lizard skin acoustic
Two coats of lizard skin heat barrier
Linex ( do stil wish that would have been enough)
5/8ths inch foam
Finally indoor out door carpet on which a coat of Linex was sprayed on the bottom
Oh yeah, that boot on the transfer case. Can’t believe I never knew there was such a boot!!!
Feel like there some success here.
Have yet to take my other friend that said I needed an intercom system and gas mask to ride in the rig
! He will be the actual confirmation! I am hopeful!
So these were the steps
Sandblast
Epoxy primer
Two coats of single stage paint
Two coats of lizard skin acoustic
Two coats of lizard skin heat barrier
Linex ( do stil wish that would have been enough)
5/8ths inch foam
Finally indoor out door carpet on which a coat of Linex was sprayed on the bottom
Oh yeah, that boot on the transfer case. Can’t believe I never knew there was such a boot!!!
Feel like there some success here.
Have yet to take my other friend that said I needed an intercom system and gas mask to ride in the rig
! He will be the actual confirmation! I am hopeful!- Thread starter
- #3,085
I had made this neoprene block before, so I just kept that in addition to the newly found boot.
RUSH55
SILVER Star
Looks spiffy, X. Nice job 
bobm
WTF, WTF, WTF!!!!
Where ya get them scuff plates nice 
- Thread starter
- #3,088
Just another one of those things that I identified as needing to be acted on immediately! Thanks Bobm!!!!!
Once again!
Once again!
