If it looks like this I'd......

[77TLCFJ40]

If your windshield frame and cage look like this....... Thank MetalTech & Choctaw (welder)

 

[shermantank55]

If your wheels look like this...

you must've filled your tires with salt water.

 

[Cruiser_Nerd]

If your gear oil looks like this.....you might want to take a look in the tranny.

 

[red65FJ40]

If your wheel stud/lug nut looks like this... i can only assume it started as a $5 "locking nut"

 

[D'Animal]

If your split case looks like this.

Better check the numbers because it was not built as a split case.

 

[2wheelbob]

If your new FJ40 looks like this...

You need to spend more time on the 'MUD' forums!

 

[DrewRunner]

If your head looks like this... you might want to look for the valve...

If your piston looks like this... you might not have wanted to find the valve...

 

[vfrer]

If your frame looks like this...

You might want to find a replacement and POR it...

 

[RockDoc]

If your 9 month old Dakars look like this, you may want to get in touch with ARB (they made it right)

 

[1974FJ]

If your engine looks like this, id.........
haha, i love this thing, cant wait to see it in person! j/k marshall

 

[splib]

If it looks like this.....


I'd buy a bullet and rent a gun!

 

[antFJ]

if your welds look like this you need to stop before you make more work for the next owner..

 

[Fast Eddy]

if your welds look like this you need to stop before you make more work for the next owner..

At least they're not in a life-critical location.

 

[metalonmetal]

If it looks like this.

Then Autocad doesn't work for getting the perfect length of your new custom springs for a 4" lift and 45 degree shackle angle........

next time use autodesk inventor

 

[Fast Eddy]

If your knuckles look like this:

You might want to think about doing a reseal.

Apologies to samwise for using his knuckles as a bad example.

 

[Farmboy0007]

Finding out why the engine ate a valve. If it looks like this (PO fix), don't rebuild it.

 

[D'Animal]

WOW

Someone can weld cast iron worse than me.

Finding out why the engine ate a valve. If it looks like this (PO fix), don't rebuild it.

 

[Trollhole]

Finding out why the engine ate a valve. If it looks like this (PO fix), don't rebuild it.

So they sleeved the lifter cylinder?

 

[Farmboy0007]

WOW

Someone can weld cast iron worse than me.

Not even sure if it qualified as weld. May have been JB.

So they sleeved the lifter cylinder?

The Sleeve is slightly off, so the lifter doesn't match the cam. It rounded out the center of the lifter like a bowl.

 

[bbalbano]

If your heavy duty front inner axle seal that you just bought from Marlin Crawler looks like this- http://i249.photobucket.com/albums/gg216/bbalbano/ih8mud/ih8.jpg

You might want to take your time and use the right tools to put it in.

Held my project up a little while until the new one came in...