- Thread starter
- #421
Finished the front heater today.
Builds 73 FJ40 Refresh (5 Viewers)
- Thread starter Engineer8000
- Start date
-
- Tags
- 73 fj40 paint job refresh vehicle tech
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #422
Rear heater back together too. Just need to add the PN decals when I install in the truck.
RevISK
SILVER Star
The Cricut is great for cutting gaskets. I’ve cut several different types of material to generally good results.
- Thread starter
- #424
Assembled the pedal bucket. I have the rubber pads here someplace but can't find them today.
- Thread starter
- #425
Headlight buckets
- Thread starter
- #426
I am putting the elephant horns back together. Had to make a couple gaskets. Still have to find the grommets.
Do you have a before pic of these buckets? What is the coating, they look beautiful?
- Thread starter
- #428
I had the buckets and rings plated yellow zinc. The outer part where the bulb rests, I was able to find as you see them. The hardware except the adjuster screws (Toyota) I got on ebay I think, SS SEMS screws. The white plastic parts are from ebay too.
- Thread starter
- #429
I put the wipers back together today.
- Thread starter
- #430
E Brake handle today
- Thread starter
- #431
I found the 1/2 x 3/8 rubber grommet fits pretty well. The back side needs trimmed a little so it is not as thick so the grommet fits flush.
Excellent …this will some beautiful presentation when you’ve finished…meticulously assembled and I look forward to seeing the completed vehicle..will be a winner for sure
- Thread starter
- #433
small wins today, pocket door
- Thread starter
- #434
Dome light. I soaked the lens in hydrogen peroxide out in the sun for about 4 hours. I think it looks a lot better.
- Thread starter
- #435
I'm trying to track down the spring for my parking brake handle. Is this it? I think it is too big and the two hooks are clocked 90 degrees from each other. about 4.5 inches long and 3/4 inch diameter.
I’ll check tonight, I have the part # as I just ordered one from Toyota
- Thread starter
- #437
Thanks, the part number I found, 90506-12023 showed discontinued.
- Thread starter
- #438
Interesting, there is a Yamaha spring that looks very much like the Toyota hand break spring, PN 90506-12023-00, could it be? Not exactly the same but maybe interchangeable?
- Thread starter
- #439
Based on the pictures I could find, I think this might be it?
