What have you done to your Land Cruiser this week? (20 Viewers)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Does anyone know the formula for removing metal oxidization / mineral deposits from the internals of a carb? Maybe electrolysis, maybe a rust remover, how long, what temp, etc.?
 
Does anyone know the formula for removing metal oxidization / mineral deposits from the internals of a carb? Maybe electrolysis, maybe a rust remover, how long, what temp, etc.?
I have used small ultrosonicator and Alconox 1832 Citranox

Screen Shot 2021-11-08 at 2.32.34 PM.png


before..
IMG_7865.jpg

after.. 1 hour...
IMG_7871.jpg


IMG_7872.jpeg


.. My sonicator is too small to fit whole part.. I just loaded half and flip it after 1 hour.. and do another half...
 
Last edited:
Looks excellent! If you don’t mind me asking how difficult was it installing the rear 4Plus dual swing out? Any mods necessary? I know they are heavy. Thanks.
Thanks! Honestly it was very straight forward but I did have to drill 8 1/2” holes in the rear. The only ones that line up are for the center receiver.

Once you mount and tighten the center section you mark the remaining holes, pull it off and drill them. The craftsmanship of it is outstanding and Dave was very helpful in every way. He also built me the front brush guard as they really don’t sell them anymore. Let me know if you have anymore questions.

29626FF6-FF6F-4458-929A-E24D7BA6F35F.jpeg
 

Users who are viewing this thread

Back
Top Bottom