white knuckles arrived
What have you done to your 100 Series this week? (82 Viewers)
- Thread starter SHUSH
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Did you put that sticker on the slider? Or they did? And how hard was the installed? I should be receiving mine in about two weeks.
they had the stickers on when they arrived. installation was very easy. I just have to check the brakelines again to make sure there is not rubbing with the slider bolts
KC HiLites 2" C-Series C2 LED Area Flood Lights!! Hooked up to the switchpro. Rear lights are on 1 circuit, side lights are on another. Cool party trick that I can turn them on from inside the house with my cell phone. 
What sorcery is this?Cool party trick that I can turn them on from inside the house with my cell phone.
I have some major things coming in the next couple weeks. New steering rack and hoses, rotors, brake pads, etc. So, to kill some time this weekend I worked on some cosmetics. My front grill is beat up pretty bad from rock chips, so cleaned it up with some plasti dip. Also, I shamelessly completely copied @ikarus in regards to the RAM mount. I was at a loss for phone storage and that solution was perfect.
Before:
After:
RAM Mount:
Before:
After:
RAM Mount:
love the ram mount and want to be a copy cat too....do you have a link to order one?I have some major things coming in the next couple weeks. New steering rack and hoses, rotors, brake pads, etc. So, to kill some time this weekend I worked on some cosmetics. My front grill is beat up pretty bad from rock chips, so cleaned it up with some plasti dip. Also, I shamelessly completely copied @ikarus in regards to the RAM mount. I was at a loss for phone storage and that solution was perfect.
Before:
After:
RAM Mount:
For sure. Here are the links down the page at the bottom. Post 179
Spent some time on paint today. PO had hard water stains from sprinklers that I hadn't taken the time to get rid of yet. Claybar, 3m rubbing compound and some wax later..... paint is clear and buttery smooth.
Also realized I haven't posted an updated pic with the 285 ko2s instead of stock tires.
Also realized I haven't posted an updated pic with the 285 ko2s instead of stock tires.
Started playing with the new steering wheel leather. This should be a big improvement over the cracked wood finish. Will post some finishe pics if I get a few hours to stitch it this week.
Looks promising, tell us more.
Rebuilt the knuckles, UCAs, lower ball joints, brake lines, brake hoses, calipers, wheel speed sensors, wheel bearing repack, etc. Alignment tomorrow.
Riverrunner
Supporting Vendor
- Joined
- Jun 14, 2012
- Threads
- 47
- Messages
- 863
- Location
- Fort Collins, Co
- Website
- www.summitautotransport.com
Added a temporary tailgate accessory. Sorry for the crap picture.
Look up Xuji steering wheel covers. Many YouTube videos with install details. Install is supposed to be easy, just time consuming. I paid $45 on Amazon.
Test fit an ammo can for under hood storage. Had this left over from my last LC. Not my original idea, someone mentioned it in a post on this forum long ago. I'll shoot it with some trim paint before I make it semi-permanent. Had jumper cables in it last time and worked well, but it is a tight fit.
Also installed new front recovery points from trail tailor
Also installed new front recovery points from trail tailor
Painted the stock wheels gun metal. Tried to match the color on my ISF
What did you use for paint on your wheels? Trying to decide on the right shade for my LC which is also white. Also waht lift/ tire size are you running in this photo?
Xena was a little dirty, so I drove through mother nature's car wash. If was not very effective.
