Replace both ujoints on the front drive shaft. Shocked at how smoothly that job went.
What Did You Do with Your 80 This Weekend? (93 Viewers)
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Started the tire carrier. Don't have much time, but here ya go. Side brace is temporary till next week, height clears taillight and lisc plate, angle matches window. Correct latch showed up today, instead of Friday. Going to hinge to the right, will clear tailgate when down as well. Figuring out the jerrycan or roto mount today and getting a materials list together for the morning. Need to find a heavy duty 2.5" hinge. Again, not finished. Adding a tensioning bolt to hold the tube tight in the hitch as well. Doesn't move at hwy speeds either. Added a roller to the bottom cause I hate hang ups!
Here's the hinge for size reference, Amazon, 11 bucks, 2,000lb rated.
Check engine light came on today, wish my elm327 worked on my 80 
Like it does with every other car in my driveway...
Like it does with every other car in my driveway...
Wiring and re-wiring. Need to get some horizontal switch covers.
Gapped my spark plugs because I didn't realize the ones I got were not pre-gapped like the other ones I was considering getting and was wondering why the idle was a little rougher after replacing the plugs. But after that was sorted out I bumped up the timing to about 5-6 deg, installed a CDL switch, did the pin 7 mod and adjusted my trans cable. Didn't notice much of any change with the timing but the trans cable adjustment has pretty much taken care of the odd slip at slow speeds when getting back on the throttle.
Which one did you go and how is it? I checked out a couple a while back and the ground was coved with spent shell casings.
TC-AB-TC-AB-TC-AB = clear.
FloridaFJ80
Roaming Land Cruiser Heaven
- Joined
- Sep 11, 2005
- Threads
- 185
- Messages
- 3,051
- Location
- Ashburn, Va
- Website
- www.landcruiserheaven.com
I am surprised he still has it. I would have thought he would have sold it after he got back. I actually met with him when he was driving through Cartagena, Colombia. Small world once again!.
Spent a few hours flushing my heater core in an attempt to figure out my no / low heat issue.
After several flushes of the front and rear core, and a CLR bath I'm sad to report I still have little to no heat.
After several flushes of the front and rear core, and a CLR bath I'm sad to report I still have little to no heat.
Did you check heater valve?
Have you confirmed that your heat blend valve is moving with the setting on the HVAC controls? I've heard of them failing. You'd need 2 people to do this I guess.
LFD2037
TEXAS LEXUS!
No need for 2. Just make sure it slides ALL the way to passenger side of heater valve on the firewall.
I'll start another thread to discuss this further.
Explored Mt. 7, around Golden, BC.
I received word that my 80 was finally going to be released from shipping jail. My company and the shipper have been fighting over what "NET 30" means, and it looks like I'm finally going to get Marjan back.
Took a walk around my new neighborhood in Germany and encountered this in a neighbor's driveway.
And yes, that is a Dakar 2010 sticker on that bad mama jama. I think I need to get to know this guy.
Took a walk around my new neighborhood in Germany and encountered this in a neighbor's driveway.
And yes, that is a Dakar 2010 sticker on that bad mama jama. I think I need to get to know this guy.
LS1FJ40
SILVER Star
SAWEET!!!!
