PIG + Chebby Avalanche Trim =?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

blast from the past- good bumpage!
 
I cut off the upper bar surround on the roof rack & remade my hi-lift mount. I also made my hydroboost hoses, new clutch master & slave, & added all fluids. Not getting fire so I'm in the process of tracking down that issue. Not sure I want to get this rewired as the harness looks good & is not hacked by the PO too bad.

1488729315074.jpg


1488729399291.jpg
 
PO? did your pig take a vacation from you? Welcome back!
 
Not satisfied with the angle of the old hydro ram mount on the axle housing, I should have fabbed it up like this from the beginning. I'll finish boxing the outsides next. I have a removable mount designed for the ram on the opposite end.

20181020_224710.jpg


20181020_224958.jpg
 
Looks good! How about some updates on everything. What do you like and what you don't. You did some great fab work that needs to be shared.
 
Steering & all associated parts are finished :p Last item to fab is I need to add braces to the front 4 link mount (outboard of the frame) as it takes the load of the front roll cage as well as forces from the axle.

20190106_185846.jpg


20190106_190011.jpg
 
@LC_Hamma, do you have a picture or two around the backside of the door opening? I was curious how you tied it in when you removed the rear door.

The rear door is not removed, just about everything behind it is :D

20190116_192836.jpg
 

Users who are viewing this thread

Back
Top Bottom