my 8274
Picked this up with a bumper for $350, I replaced all the wear parts and painted it all, total came to $350 from driveline products here in Canada. I wanted to take a whole bunch of photos, but in the end once i got my hands covered in oil, i could only stop so many times to clean up and take a photo.
First post, but figured since I used this thread to rebuild mine, I would add a little bit to it.
Paint is duplicolor enamel cast aluminum color, and the black is tremclad black. Turned out pretty good I think, electrical to be done tomorrow and will bench test it, I have no worries tho, worked before I took it apart, should work fine now that its back together.
this video:
Warn 8274 Rebuild video # 2 Re-assembly of winch - YouTube is what I used to put the brake back together, worked like a dam, got it on my first try with just a simple pair of vice grips. In this video tho he doesnt show installing the keys, so once its clamped, i slid in the keys and then installed the snap ring.
was a pain to get the assembly back into the winch with the little piece of cardboard used to seat the seal, i found I had to keep the brake clamped, hit the end of the shaft with a hammer until the seal was seated, and then remove the cardboard, and clamp for the shaft to then slide into its bearing enough that the locking plate could slide into place. Not sure if that makes sense, i would have loved to have documented it better.
Ill add a handful more pictures once the selenoids and wiring is done.
I do plan on searching for another used one of these, see if i cant get a rusty one for under $200, I will try and document that one better.
this one serial 36664, date code BB0
--->MATthe link to the facebook album is way easier than me copying all the image locationshttps://www.facebook.com/media/set/?set=a.10151604409250012.839916.604055011&type=3&l=fabaae3dd0
