Builds My first '40 and the venture (1 Viewer)

[OlYellr]

 

[RevISK]

Get it B!

 

[OlYellr]

Get it B!

On it this week. Roughy it, maybe weld other side Thursday.

More paint while weather is warm, maybe cut the other side too if the “paint booth” is done for a while.

 

[OlYellr]

Here is the almost done tank and the skid plate from being blasted…

Going to put a rubberized undercoat on bottom of tank

And

And

 

[OlYellr]

Cut the driver side to do prevention-

Yellr took a dump on the floor after cleaning behind the plate. Mind you, cleaned before and shop vacuumed too before.

So after cleaning etc, exposed this gem hiding behind where the inner channel was removed and cleaned

Put a light on it inside frame. Image from below…. Frick.

 

[RevISK]

Dang, glad you found the cheese so you can repair. Tank is looking great, I need to do something about mine I think. Looked fine when I pulled the sender but should probably throw a probe in there or drain for the real story.

Yellr's going to be tight!

 

[OlYellr]

Lots more to post.

This may make your day Ian, I’m going to tack the plate on soon now that the hole is addressed.

Picts to follow.

Got it secured

 

[OlYellr]

taking a break-

Drilled out the holes

 

[OlYellr]

Also using some Eastwood stuff

Before underneath

After

Next will be this…

 

[MOTOV8R]

So the frame....

Rus made a gusset for the front. I like what he came up with. A clean look for sure. This will be part of his kit.

View attachment 3793461
more...
View attachment 3793464
and...
View attachment 3793465

@solomrus would you be willing to sell these plates by themselves?

 

[OlYellr]

For the cheese on the driver side as Ian called it

The solution was more involved…
Cut it out…

Make a patch and add a buttress for the inside frame

Still hot from welding and can see the vertical brace

 

[OlYellr]

@solomrus would you be willing to sell these plates by themselves?

Just told Rus

 

[OlYellr]

@RevISK and I were on the phone discussing eigenvalues, gusset angles a couple days ago… said the gussets looked vertical. They angle back about 12 degrees.

Anyway… driver side outer gusset on to add more lateral strength

Here is how the cheese wiz patch came out

From the bottom

Eigenvalues…

 

[OlYellr]

Me tacking the plate on now on driver side..

And there is where things are at the moment

 

[MOTOV8R]

That looks solid. Is all the plate 3/16”?

 

[RevISK]

Tacks look good B. and Run lays a mean bead on that gusset. I need to get on his list for those.

 

[RevISK]

Tacks look good B. and Run lays a mean bead on that gusset. I need to get on his list for those.

Makes me want to go weld something.

Back to trans swap prep.

 

[solomrus]

@solomrus would you be willing to sell these plates by themselves?

We absolutely would be.

Hit me up via DM and we'll see if we can get you sorted out. 8^)

--r

 

[solomrus]

That looks solid. Is all the plate 3/16”?

Yes, everything we're working with here is 3/16".

--r

 

[OlYellr]

Dropping Poem early - running out of time and will get worse, so might as well..