Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Do the LS430 visor slide out to become longer??
Do they swing to the sides without issue?I found these out of a 2003 LS430 at the local junk yard. Bolted up without any mods. I might wire up the mirror light later. The lighter color is not as noticeable in person.
View attachment 1986316View attachment 1986317
How much? Pm meCompleted LS400 visors install yesterday. Should have done this years ago. Local U pull had a couple extras.(about to throw them up on classifieds)View attachment 2096462
How much? Pm me
I 3d printed hook brackets, since mine didn't come with them
View attachment 2096786
80 Series Visor Fix With LS400 Visor Clips and Mounts - Etsy
I swapped out the visors in the fj80 for LS400 visors, and the old clips were too small so I printed these. Comes in a pair.www.etsy.com
Hollywood,Just one tip for you guys... swap out the mounting bracket from your land cruiser sunvisor onto the LS sunvisor. You have to widen the opening a little bit using a 13/22 and 27/64 drill bit (it needs to be a tapered opening). BE CAREFUL NOT TO DRILL ALL THE WAY AND DAMAGE THE TABS THAT HOLD THE BRACKET ONTO THE SUNVISOR.
Just did this install. Ordered parts as described above from eBay.
On the LS400 part that holds the visor up, I had to cut a round insert and a square(ish) screw tan off flush. Wasn’t quite sure if this was the correct route but after looking at it for a few minutes, this was the only way it was going to install using the screw from the LX450.
I used 95-00 LS400 visors for this mod on a 97 LX450. I did not connect the wires for the mirror light. This took all of 10 minutes to install and has absolutely cured my saggy visors.
Great mod! Strongly recommend!
Thanks OP for putting this one together!
I made the spacers, find a place to get them printed and enjoy. They work really well. can i upload .stl's here?