Since this seems to be the Sniper info thread and I've posted a lot of stuff here so far, I want to add something else so everyone considering this is aware.
I had what I thought was a fuel injector go bad. One of 4 stopped firing altogether. I called Holley about buying a replacement injector and was told that they don't sell the injectors separately, that I would need to send the unit in for service (4 new injectors) at a cost of $200. I've also heard that Holley doesn't sell ECUs separately. The rest of the parts are available. TPS, IAC, O2 sensor, and coolant temp sensor. I've had to replace a couple of those sensors because Holley seems to be using less expensive components for these. Quality replacements are not very expensive but it's a PITA and unnecessary. I'm a little concerned about future support for the Sniper if this is their current business model ... not all parts available for this system.
The problem with my injector seemed to be a bad connection at the wire connector, the plug isn't retained very well, and it seems to be a recurring problem. Easy fix with a little zip tie or a spot of glue. One guy is talking about 3d printing up little plastic retainers, something that Holley should be taking care of, obviously.
I just wanted to get this out there for anyone considering this system.
Brian.
I had what I thought was a fuel injector go bad. One of 4 stopped firing altogether. I called Holley about buying a replacement injector and was told that they don't sell the injectors separately, that I would need to send the unit in for service (4 new injectors) at a cost of $200. I've also heard that Holley doesn't sell ECUs separately. The rest of the parts are available. TPS, IAC, O2 sensor, and coolant temp sensor. I've had to replace a couple of those sensors because Holley seems to be using less expensive components for these. Quality replacements are not very expensive but it's a PITA and unnecessary. I'm a little concerned about future support for the Sniper if this is their current business model ... not all parts available for this system.
The problem with my injector seemed to be a bad connection at the wire connector, the plug isn't retained very well, and it seems to be a recurring problem. Easy fix with a little zip tie or a spot of glue. One guy is talking about 3d printing up little plastic retainers, something that Holley should be taking care of, obviously.
I just wanted to get this out there for anyone considering this system.
Brian.