FJ62 crank but no start (1 Viewer)

[bluefj62]

After replacing my thermostat, belts, radiator, and fan clutch my FJ62 cranks but no start. I checked EFI and IGN fuses and they’re good. I can shoot carb cleaner into intake and it fires. It was starting, running and driving without issue when pulled into garage for cooling system maintenance. Could I have disconnected something on the front of the engine that would cause this?

 

[89BIGBLUE]

Hmm.
Double check that all the sensor connectors to the thermostat housing are connected correctly, and in the right spots.
Confirm fuel is getting to the intake?
There’s a EFI relay on the pass fender well that acts up on mine sometimes.

 

[Old Nick]

Hmm.
Double check that all the sensor connectors to the thermostat housing are connected correctly, and in the right spots.
Confirm fuel is getting to the intake?
There’s a EFI relay on the pass fender well that acts up on mine sometimes.

x2 on the relay.

OP, are you getting any unusual clicking from the pass fender?

 

[bluefj62]

x2 on the relay.

OP, are you getting any unusual clicking from the pass fender?

There is nothing clicking that I’ve noticed. Does anyone have a picture of the relay being discussed?

 

[89BIGBLUE]

Here: