- Thread starter
- #61
For factory style I cut out the metal and fabbed a piece to install which u can see on back side. The flush one just cut 45s on both sides of rib , straighten metal and hammer to 45. I will post some pics when I start it.
Builds 1963 FJ45LP Project (1 Viewer)
- Thread starter miller
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #62
Made new rear corner channels. Removed old and fit new ones. Waiting on some primer to install. Started finishing bed floor rib end caps.
- Thread starter
- #63
A few more pics. I went with a 30 degree angle for the caps.
- Thread starter
- #64
Are these brackets original? Maybe a gate cushion or stop.
tahoe40/45
SILVER Star
Not original, lip on tailgate stops it, rubber strips for cushion.
Rear Drop Down Gate Weatherstrip Kit for Land Cruiser FJ40 BJ46
Calm your rattling rear drop down gate with this weatherstrip kit. Reintroducing discontinued part numbers 64923-90300 (1x) and 64922-90302 (2x). Accurate reproduction based on NOS samples. Fits all years of Toyota Land Cruiser FJ40 or BJ46 equipped with rear drop down gate (as opposed to a...
www.cityracerllc.com
- Thread starter
- #66
Finished up floor sections. Installed rear corner channels, floors and fit rear sill. Tomorrow welding rear sill corners.
- Thread starter
- #67
Welded up rear sill corners.
Great work! And I’ve got major table envy!
- Thread starter
- #69
Thanks. I got that table a couple months back I use it all the time!
Yes looks great! And yeah Where did you get the table?!
- Thread starter
- #71
Buddy upgraded to a larger table so this was his old one.
- Thread starter
- #72
Fit rear crossmember aft bed mount and located mounts. Need to weld and install mount supports. Bent up qtr panel to fit rear channels. Cut and fit qtrs. I should be able to weld in rear sill and qtrs next weekend.
- Thread starter
- #73
Otherside.
- Thread starter
- #74
Passenger side lower qtr was too rough to save. Fabbed new one turned out pretty good.
- Thread starter
- #75
Made step flanges on both cross-braces and rear mount brace. Added recess to rear mount cross-brace for mount brackets.
- Thread starter
- #76
Welded rear sill in place and both qtrs.
tahoe40/45
SILVER Star
Nice work!!
- Thread starter
- #78
Pulled WW tub for repairs.
- Thread starter
- #79
More WW work.
- Thread starter
- #80
Sandblasted WW tub at work and then used spot blaster to do fender area. Primed everything with weld thru and installed. Should be able to weld it in tomorrow.
