The seat covers are new not used. They have a couple scuffs from storage/ moving the seats around. I bought these for my 1970 but going black instead of coral. These seats are pre 70. They have different brackets than the 1970. I will ship. $650
I did score a 8274. It was taken all apart for a rebuild, but never finished. Verified it was all there with the rebuild kits for $500. Reasonable in todays world!
I’ve done about two heat cycles up to temp in driveway and still blows baby blue smoke everywhere! Exhaust manifold is blowing oil past gasket and carb base leaks some fuel. Might try to get this 2f running on a stand and see if it smokes. I’m...
l think I need to burp the wheel cylinders. @Drake2 said he saw some posts about it so went digging and found a post where Mark recommended how to do it.
I have bled brakes several times now. I get good flow out of all bleeders with no air. You let truck sit for a couple minutes and pedal goes to floor. A couple pumps and good to go. Maybe bad new master cylinder? I don’t have any fluid coming out...
Tech:
Fixed the wiring for the drivers seat. Now wife can almost reach the pedals again. Seat heaters would be nice- I need to hook those up some day…
Oil leak from the (freshly installed) transfer case seems to have slowed. Maybe it’ll stop...
I have been using the cheap ones off Amazon to get things apart but the hole they make is a bit big so if I need to reuse the piece I drill it with quality 1/4” drill bit then open it to 5/16” for a plug weld. I use a Snap-on tap&die set.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.