replacing

Hi Everyone, The drivers seat of my 2000 LC (130k miles) is sagging on the left side. I'm planning on replacing the foam. Read a lot of threads on how to do this. But I couldn't find anything on the springs in the seat, and I was wondering if these could become sloppy on one side and could be...

My starter failed. Prior to failing, my engine would typically fire to life after engaging the starter for maybe half a second, to perhaps a full second. I replaced the starter, and as part of the process replaced various gaskets, knock sensors, and coolant sensor (not sure if at all related)...

Yellow arrow is pointing at the thing.

Hey everyone, I thought I'd share the speakers I installed in my Landcruiser front doors today while keeping the original grill. Maybe it'll help someone out. They're the Pioneer TS-G1620F-2 2-Way 6.5" Speakers. They're actually a bit too deep and just touch the window frame thing, but it...

Morning all. I have a 2011 LC200 stock, 130k miles. Its lived its life in NJ and the underneath looks like it (certainly rusty - but not awful). I will snap some pics when I get it up on the lift. I had a friend who does suspension lifts (mostly on American brand trucks) have a look and...

Here’s a basic question: When replacing vacuum lines on the HAC valve, the book references Left/Right for the various lines. Is this when the value is viewed from the top, or if looking straight at the ports? This makes a big difference in routing the lines.

has anyone replaced their ML tweeters? thinking about ordering them from impex. i assume they are both the same p/n (i.e. not side-specific) 86160-0W300?

Just started a complete suspension upgrade on my LJ73. Everything was pretty much worn out when I got it few weeks ago. I replaced the steering dampener with OME and replaced completely dead front shocks today with OME NitroSports. Amazing difference in front end firmness already and half of the...

I had to replace radiator (lifetime warranty) and I took to the same guy who installed one 4 years ago. Next day I started the truck and noticed airbag light is on. I am sure mechanic had to remove the battery in order to install radiator. Now my question is, why airbag light came on...

Someone sideswiped my 62 and broke the mirror. You can see the carnage below. I was hoping to replace the mirror, but it looks like the only part available is 87940-90A09 complete unit, manual only? Has anyone had better luck than me replacing a mirror?

Hi everyone, the voltage regulator is done in the hj47 i believe. adjustments this morning did nothing and produces like 12.5 while driving right now, so Iwana swap it out. started looking for oem and had a hard time. found some F.D ones and then saw a hella one made by denso for pretty cheap...

Hi there, I recently became the owner of a 100-series I love dearly. However, I've been having an issue that I can't seem to figure out. When purchased, I replaced the AC compressor right away. With the new compressor, I noticed as I accelerated with the AC on, that there was a subtle...

Replacing leaf spring bushings, The bolts that are on there, bolts look original, very hard to remove. Photo's i've sen they look rough. Should I just just replace with new? Seems like i should have them on hand before I start the process? Are there better options than OEM? (greasable?)...

I have oil leaking from the rear differential inspection cover gasket (minor leakage) on the outside of the Axle housing Carrier gasket on the inside of the Axle housing. My question is whether these gaskets can be replaced without tear-down and removal of the Pumpkin and axle shafts? All...

I’m buying some globes from Japan because someone recommended I should replace them on my high mileage 06 LX. My question is, would it be better to just get the globe or is there any reason to get the whole accumulator assembly which is part 49051-60020 and 49052-60020 for right and left sides...

Since lifting my 2007 FJ last year my inner boots started leaking. I did a quick fix last summer with some grease and new clamps. Just recently I noticed the boots have now blown out. It was recent but I'm just not sure when it happened. Not noticing any squeaking or clicking. Considering...

So I have a GCC spec 1FZ-F 80 with a H151f and K194 lockers (in case any of these details are relevant to the question, hehe). I have to replace the clutch release bearing since I have developed crickets in the transmission, and I am wondering whether this is the time to upgrade the 5th gear -...

I have a new OEM pump and high pressure line. I watched the YouTube video, read the 'mud thread on replacing it, and have everything loose. I can't get it to snake out the bottom and realize that even if I did get it out, Im not sure I can get it back in correctly without messing something up...

I'm getting ready to do some body work on my 73 FJ, I want to replace the rear sill that's rotted away and do some patch panels in the corners. The rest of the tub is not that bad so I don't want to pull it off the frame. My question is can I replace the rear sill without pulling the tub?

During the process of replacing shoes today, noticed severe scoring on inner surface (outer is smooth), symptoms are juddering felt through seat (not through steering wheel) … will service ebrake/handbrake whilst there … calipers are fine for now (sliders move smoothly) … anything else? New OEM...