Hi guys,
Putting in new clutch in my 69 Fj40, all stock, 1F with three speed tranny. All going well till I installed the release lever. It appears that the fork is sitting below center of the clutch housing and when installed the TO bearing will not ride the clutch levers properly. I am banging my head trying to figure out what I have done wrong here. Flywheel resurfaced, new clutch disk, pressure plate, pilot bearing, hub and TO bearing and used clutch fork, (same as one removed that was badly worn on TO contact points.)
I don't get it, any ideas? Hope these pictures might help.
Putting in new clutch in my 69 Fj40, all stock, 1F with three speed tranny. All going well till I installed the release lever. It appears that the fork is sitting below center of the clutch housing and when installed the TO bearing will not ride the clutch levers properly. I am banging my head trying to figure out what I have done wrong here. Flywheel resurfaced, new clutch disk, pressure plate, pilot bearing, hub and TO bearing and used clutch fork, (same as one removed that was badly worn on TO contact points.)
I don't get it, any ideas? Hope these pictures might help.