It will fit with all the wrapping no problem. I just hope you have a large trash to dispose of all the wrap LOL.
What have you done to your 100 Series this week? (85 Viewers)
- Thread starter SHUSH
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Or pay $70 and "Work from your garage" while waiting for the early Xmas gift to be delivered right to your home 
There is a bumper in there…some assembly required.Or pay $70 and "Work from your garage" while waiting for the early Xmas gift to be delivered right to your home
About to install the Ass-Fur skids. Waiting on a Fumoto valve from Amazon so I can do one last oil change before install. I really wish they wouldn't put their logo on the front skid.
I got my wheel wells all cleaned up and looking nice. The brake calipers got painted, and I replace my dented-up grease dust caps since one of them was coming off from being deformed. It's essentially rust-free, but it had some little rust spots from rock chips, so I gave the lower control arms a coat of rust reformer.
Part number for the black lug nuts?
You painted the calipers whilst in the truck? I've been thinking of a refresh as well
Yes. I took the calipers off and removed the pads and hardware, but I just left the hoses connected. I hung the caliper from the UCA and put a piece of cardboard behind it to mask the area off from the caliper paint. Normally, I'm a stickler for details and I would prefer to do a full tear down before painting, but I have a set of Slee brake hoses that are going on soon, so I didn't mind the overspray on the old ones.
She’s still just a babe, congrats!
Thank you- i am going with these
Toyota Tundra Sequoia Land Cruiser Black PVD Lug Nuts Set of 20 PT076-0C200-02
hope they work
6 days later, the tracking number is still showing “label created” and no movement. Frustrated at this point, I call and cancel my order, get a refund, and place an order with my local dealer. Luckily they had 1 left at their local warehouse and it will be ready for pickup tomorrow. My vacation starts on Friday…
While removing the PS pump in preparation for installing the replacement tomorrow, I notice the inner tie rod boot is ripped. FRICK. It just keeps adding on.
Does anyone know where I can get a replacement ASAP?
awesomeissquid
SILVER Star
Might find something useful here:
Tie Rod Ends.....are boots available? - https://forum.ih8mud.com/threads/tie-rod-ends-are-boots-available.1057219/
Very helpful. TY! If the toyota dealer doesn't stock the boot i'll see if I can go the Oreilly route.
Just found the part number from Toyota: 45535-60010
Last edited:
I took a peek at her while sipping coffee, don’t worry guys, she is still there where I left her…. 
i just used beck/arley boots when I did my inners, seem to be of good quality and more flexible than the ones on the rack the PO installed(not sure if he went oem Toyota but I doubt it)
ramangain
Clarksonian disciple
Thank goodness. I've been fighting explosive diarrhea all day worrying about her too.I took a peek at her while sipping coffee, don’t worry guys, she is still there where I left her….
still have roof rack off and it leaked inside the other day from the rain, so the cruiser umbrella was deployed
