What have you done to your 100 Series this week? (29 Viewers)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Debadged the Hundy today!! Hated the gold. Just my opinion though!!:D

image.jpeg


image.jpeg


image.jpeg


image.jpeg
 
IMG_0407.JPG
Finally switched over to the MT 275/70 R18's I had laying around onto the Tundra wheels. Thank goodness they weren't 285's like I thought. Looks like I will be cranking the torsion bars then maybe a lift in her future with a diff drop. They sure make it a rumble wagon going down the pavement. It actually seemed to smooth out at a higher speeds. We are close to 190k miles now. I need to go back through the tire and lift threads.
UZJ100front.jpg
 
Last edited:
Finally installed new hood struts after they rode around in my trunk for the last 6 months. Took about 15 minutes. Sheesh.
 
Some 18" Tundra wheels and Copper 295/70R18 STT Pros today.
Super close to rubbing on the SPC UCAs. Have 1" spacers on order.
With the OME 864 springs, need to adjust the rear upper/lower control arms now as well.
HIH6 here I come...

IMG_2876.JPG
 
Cranked up T-bars to level out. Raised 7/8" with 4 turns on LH, 5 on RH. Now I need to put the drawers back on to see where I stand! Without them there I'm 1" higher on the back r now.
image.jpg
 
I'm also doing some changes on the drawers, reason why they are out!
 
image.jpeg
image.jpeg
image.jpg
Installed my slee gas can holder onto my slee rear bumper. Love it! 10 minute job. Seems like a nice place for a cooler too!
 
Installed a new set of Michelin LTX M/S 275-70R16s, Toyota was running a buy 3 and the 4th for $1. Couldn't beat the price.
 
Yanked my running boards off (even though mine were aftermarket and not as ugly as the OEM version). Raised the front a littl earlier this week so it sits with an inch of rake then had it realigned. Removed the back carpet and cleaned about a pound of sand out. PO obviously enjoyed the beach. On the upside I found my OEM sub was replaced with a Kicker CompRT 6.75" microsub. Just need to wire an amp up to it.

Before:
26271324614_eb1f3c2c4b_c.jpg


After:

26876748395_2ec631a354_c.jpg


Carpetless:

26809150511_c193fc05e4_c.jpg
 

Users who are viewing this thread

Back
Top Bottom