Cleaned out its winter home and slipped her inside.
What Did You Do with Your 80 This Weekend? (68 Viewers)
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
suzuguru
SILVER Star
I was sitting here looking at that wall and the house in the background of your picture, and was like... man, that looks like Hawaii. lol
suzuguru
SILVER Star
You live in the South. Do you really keep it put up all winter?
Saved Jeeps.
Ecliff5
SILVER Star
- Joined
- Jun 21, 2011
- Threads
- 233
- Messages
- 21,825
- Location
- Redding, California
- Website
- trail-tailor.com
On website now. 1 remaining as of a few minutes ago.
80 Series On Board Air Kit
Toyota Land Cruiser 80 Series 1FZ-FE York OBA Kit Kit includes: Bracket made from ¼” HSLA steel - powdercoated 6061 aluminum 3 groove pulley - hard anodized Toyota tensioner assembly Toyota tensioner bolt V-belt Modifications or deletion to the heat shield, pair valve and heater lines may be...
trail-tailor.com
J
Thanks, I already purchased all the parts from Amayama, listed in this video by Timmy
He didn't mention the PHH.
The PHH is only a little bit of straight hose. If it looks like it needs replacing, that won't be too hard to fabricate.
Last edited:
I have a heater and dehumidifier in the shop for a reason.
Nope. Doesn't work. It'll rust away.
I used mine to get a tree.
We are doing a rookie level snow run next weekend, so it's going to stay dirty until after that.
No no no. She just been in beast mode all spring/summer/fall and I like to give her a break during the cold months. Still a daily driver
Josie'sLandCruiser
Stop calling it a "FJ."
IKsokudo is this evaporator related to the AC system? Where is it located on a FZJ80? Thanks!
suzuguru
SILVER Star
Gotcha. I grew up on Signal Mountain. My mom still lives there.
Replaced the throttle cable, It doesn't even feel like I'm driving the same truck! I also replaced the steering wheel clamshell. Fixed a few little things, new grommets, unhooked ground ect.. but found at least 5 other things that need attention. I also added some heat shield to the harness by the EGR valve.
Same place as FJ80 behind the glove box it’s not hard but not easy either.
search the threads there’s a good write up.
You will have to recapture the r-13 r134 unless yours leaked out like mine. I ordered a new evap core , expansion valve and drier from rock auto. The core was my leak issue all that gunk and water from condensation over the years took out the bottom. Also found threads on the closed foam for resealing the areas between the blower. Evap box and diverter doors
Last edited:
That’s the condenser I would have loved if it was that. This is the evap but a good video for reference re condenser.
woops. I should've mentioned that the video starts with taking out the evap core. But yes, the screenshot shows the condenser.
Hah! I follow them on trails so not for long. It actually does still fit in the garage but only on a full tank!Ooo. Good looking truck!! A little more polished than some of the Cruiser boys I know in Huntsville (@Zjohnsonua). Too bad it won’t fit in the garage anymore?
JohnnyFish
GOLD Star
I learned that if you consult a 1994 FSM wiring diagram when wiring in a new alternator pigtail on a 1996, you let the blue smoke out. : /
