Anybody know where I can get the injectors serviced in either York or Lancaster counties?
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Progress .... keep getting hung up on stupid things like waiting on my kid or wife to help guide me to the rearmost plenum bolt so I can remove the upper half and getting the small internal coolant connection pipe to come out of the lower portion near the thermostat.
View attachment 1944161
Haven't snapped anything off at this point, so WIN. Decided that rather than located and disconnect all the clips on the drivers side that haven't been apart since Clinton was President I will try to unhook the main plug inside and feed it backwards through the plenum. Many fewer connectors that way and I already have the 3 undone near the oil filter, just need to locate the VVT hoses still and I can cut them and replace if needed.
Would it really have been that hard to design the plenum to have the bolts on the top ... sheesh. Hoping to have the head off by the weekend if all goes well. Hoist and trolley for the I-beam in the garage should be here Friday and the other parts are showing up daily. @Crusha ... I'm already double your initial estimate in parts and tools.
I hope pulling the wiring harness down through the intake works for you. I followed the F.S.M and pulled everything up through... a royal P.I.T.A... transmission connectors especially near impossible to disconnect.
Floor jack?Looking for some help on a stupid unforeseen issue ... I need to roll the truck back ~20" to position under my hoist. I expected to be able to just cycle the key to the on position and roll it, but it won't come out of park and the main harness has already been unplugged from inside the truck.
Anything I can do here?
fulltime 4wdFloor jack?
Remove drive shaft at pinion flange only. Both of themfulltime 4wd
Wouldn't the center diff let it roll if one axle is up?fulltime 4wd
And I bought some of Eastwood's Rust Converter, used it on some driveline parts to test...
View attachment 1952701View attachment 1952702View attachment 1952703View attachment 1952704View attachment 1952705
Works more better then the Gemplers I have been using.
Very carefully measuring, laying out and making a jig to hold both bellhousings before I cut them in half. Then I tacked them in the jig and bolted it up to the tranny to verify before welding.Andy that looks awesome. How did you maintain the proper centerline/alignment of the transmission input shaft?