U-bolt torque and thread length (3 Viewers)

[georgebj60]

Some RTH needed. How critical is the exposed thread length at the front u-bolts? The service manual says to tighten to 90 ft lbs, ensuring the exposed length of the u-bolts is consistent. I understand mine will likely be longer at the back as I have caster shims installed, but they’re longer at back vs the front by more than the shim thickness. Is there some rocket science here, or is it snug to 90lbs and call it a day?

At least it looks like my exposed threads are even left to right.

 

[georgebj60]

Actually on second look, the difference in thread length is pretty close to the shim thickness. I’m going to carry on.

 

[Godwin]

After you run them a few days, couple hundred miles or so, recheck the torque. You may need to do this 2-3 times before you reach the point where re-torquing remains tight.

 

[georgebj60]

It seems like I’ll never get to 90lbs torque. I stopped at about 80. Feels like they’ll just keep turning.

 

[duncanrm]

It seems like I’ll never get to 90lbs torque. I stopped at about 80. Feels like they’ll just keep turning.

Hahaha.. I hate that sensation of second guessing the torque... "am I about to break it or does it really need to be this tight???"

 

[georgebj60]

Hahaha.. I hate that sensation of second guessing the torque... "am I about to break it or does it really need to be this tight???"

Exactly! Plus I’m not sure I trust my torque wrench. It maxes out at 100lbs so I’m near the limit. I need a bigger one anyway so I might grab one and double check the bolts.